Drolet ECO-45 - Manual

ECO-45 FREESTANDING PELLET STOVE Width: 27” Height: 30 1/2” Depth: 24 5” Weight: 230 lbs. Flue size: 3” or 4” Hopper Capacity: Up to 60 lbs. (This can vary widely depending on pellet size, length, and diameter) EPA status: exempt Burn rate: 1.3 lbs to 5.5 lbs per hour BTU range: 8,200 to 45,000 Elec...

COMBUSTION AIR SUPPLY For a mobile home installation the stove must be connected to an outside source of combustion air. A 3” inside diameter metallic pipe, either flexible or rigid, may be attached to the inlet at the stove’s rear (refer to figures 4, 5 & 6). A rodent guard (minimum ¼” wire mes...

Equivalent Vent Length (EVL) The longer the run of pipe in your installation, the more restriction there is in the system. Therefore, larger diameter pipe should be used. • Use 4” pipe if you have more than 15 feet of Equivalent Vent Length (EVL). • Horizontal runs shall not exceed 10 feet of EVL. •...

A. VERTICALLY WITH NEW CHIMNEY SYSTEM (Refer to Figure 9 & 10 for basement installation) NOTE: Follow the vent manufacturer’s instructions. OPTION: To achieve a center vertical installation, a 45º elbow and a clean-out tee can be used to offset the pipe from the exhaust outlet to the rear center...

OPTIONAL LOG SET INSTALLATION To install the optional log set, you first need to remove the four screws indicated on figure 14a. Keep the screws. Locate the two fixation brackets figure 14b that came with your owner’s manual. Fix the two brackets using the same screws you have removed. Lay the log s...

PROPER FUEL THIS STOVE IS APPROVED FOR BURNING PELLETIZED WOOD FUEL ONLY! Factory-approved pellets are those ¼” or 5/16” in diameter and not over 1” long. Longer or thicker pellets sometimes bridge the auger flights, which prevents proper pellet feed. Burning wood in forms other than pellets is not ...

a. MODE SWITCH • When the mode switch is pressed, the stove will automatically ignite. If the manual mode is selected, the heat level must be selected manually to adjust the stove’s heat output to the desired level. If the thermostat mode is selected, the stove will automatically modulate between th...

IF THE STOVE RUNS OUT OF PELLETS The fire goes out and the auger motor and blowers will run until the stove cools down. This will take a few minutes. After the stove’s components stop running, a warning message will appear . To restart, press the “RESET” button, refill the hopper , and press the “FU...

OPERATING THE STOVE USING A THERMOSTAT A thermostat may help you maintain a constant house temperature automatically. A millivolt thermostat or 24 Volt thermostat is required. A fixed wall mount or hand held model can be used. The control panel can be set up two ways to operate your stove in thermos...

FAILURE TO CLEAN AND MAINTAIN THIS UNIT AS INDICATED CAN RESULT IN POOR PERFORMANCE AND SAFETY HAZARDS. NEVER CLEAN WHEN HOT. NOTE: Inspect burn pot periodically to see that holes have not become plugged. If so, clean thoroughly. ASH REMOVAL Ashes should be placed in a metal container with a tight-f...

VACCUM USE If a vacuum is used to clean your stove, we suggest using a vacuum designed for ashes. Some regular vacuums and shop vacs leak ash into the room. Your vacuum or shop vac may have a special filter or bag available to eliminate this leakage. CLEANING a. Heat Exchange Tubes – Your ECO-45 sto...

When your stove acts out of the ordinary, the first reaction is to call for help. This guide may save time and money by enabling you to solve simple problems yourself. Problems can be caused by to only five factors: 1) poor fuel; 2) poor operation or maintenance; 3) poor installation; 4) component f...

WARNING CODES CHART MESSAGE CORRESPONDING WARNING Pressure switch warning. L-250 automatic high temperature switch, located under the auger. L-250 manual reset high temperature switch, located beside convection blower. Hopper is empty Lighting warning. Hopper lid stay open more than 3 minutes. Inver...

CONVECTION BLOWER F-160 N.O. CONTROL BOARD FRAME GROUND L1(LINE NO CONNECTED) L2(LINE COMMON) L1(LINE HOT) AIR FLOW PRESSURE SWITCH N.O. L-250 N.C. L-250 RESET N.C. L-250 N.F. THERMISTOR THERMOSTAT TERMINALS N.O. HOPPER LID SWITCH N.O. COMBUSTION/EXHAUST BLOWER AUGER MOTOR IGNITER HIGH TEMPERATURESW...

Contact an Authorized Drolet Dealer to obtain any of these parts. Never use substitute materials. Use of non-approved parts can result in poor performance and safety hazards. ITEM PART # Airflow Pressure Switch 44029 Air Switch Hose 49004 Auger Motor 44038 Burn Pot PL52545 Control Board 44032 Combus...

REPLACEMENT PARTS HORIZONTAL AND VERTICAL VENT CHART Let’s imagine an installation consisting of a horizontal vent coming out at the back of the stove on a total distance of 8 feet. This horizontal run is followed by a Tee and a 6-foot vertical rise. This type installation is not acceptable. As you ...

APPENDIX B 28 int. ˆ ext. ˆ Name Address City Province / State Country Home telephone Work telephone Purchase date Model number Serial number Installation date Installator name Installator telephone Type of pellets Thermostat Yes ˆ No ˆ Outside air Yes ˆ No ˆ Ignition gasket / 2 magniglass Yes ˆ No ...

DROLET LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original consumer purchaser and is not transferable. This warranty covers brand new products only, which have not been altered, modified nor repaired since shipment from factory. Proof of purchase (dated bill of sa...