Drolet DB03060 - Manual - manualsarea.com

Page 2 - TABLE OF CONTENTS; REGISTER YOU WARRANTY ONLINE

TABLE OF CONTENTS INTRODUCTION ............................................................................................................... 2 ASSEMBLY ....................................................................................................................... 3 INSTALLATION ..............

Page 3 - INTRODUCTION; . It will provide you with a full

2 INTRODUCTION STOVE BUILDER INTERNATIONAL INC., one of the most important wood stove and fireplace manufacturers in Canada, congratulates you on your purchase and wishes to help you get maximum satisfaction from your wood stove. In the pages that follow, we will give you advice on wood heating and ...

Page 4 - ASSEMBLY; Ash lip Installation:

ASSEMBLY Legs installation: Position the stove on its back and screw the legs in place with 8 screws, 8 bolts, and 8 washers; Ash lip Installation: Screw in place with 2 bolts, 2 screws, and 2 washers. 3

Page 5 - Cast iron flue collar installation:; Install the bottom firebricks

Cast iron flue collar installation: 1. Peel off the tape from the back of the gasket and attach the gasket to the rope groove at the back of the flue collar; 2. Mount flue collar on top of the stove. Make sure that the damper holes on each side of the flue collar are parallel to the back of the stov...

Page 6 - INSTALLATION; POSITIONING THE STOVE

5 INSTALLATION SAFETY NOTICE • I F THIS STOVE IS NOT PROPERLY INSTALLED , A HOUSE FIRE MAY RESULT . T O REDUCE THE RISK OF FIRE , FOLLOW THE INSTALLATION INSTRUCTIONS . F AILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE , BODILY INJURY , OR EVEN DEATH . • C ONSULT YOUR MUNICIPAL BUILDING ...

Page 7 - CLEARANCES FROM COMBUSTIBLES; Single pipe / Double pipe; A B C D E F

CLEARANCES FROM COMBUSTIBLES It is of outmost importance that the clearances to combustible materials be scrupulously respected upon installation of the stove you have selected. Refer to the tables below : Single pipe / Double pipe A B C D E F 29” 30” 39” 34-3/4” 22” 32” • Floor to ceiling height mu...

Page 8 - CHIMNEY

7 CHIMNEY Your wood stove may be hooked up with a factory built or masonry chimney. If you are using a factory built chimney, it must comply with UL 103 standards; therefore it must be a Type HT (2100°F). It is extremely important that it be installed according to the manufacturer's specifications. ...

Page 9 - Stove Pipe

CHIMNEY CONNECTOR (STOVE PIPE) The stove pipe must be made of aluminized or cold roll steel with a minimum thickness of 0.021" or 0.53 mm. It is strictly forbidden to use galvanized steel. Your smoke pipe should be assembled in such a way that the male section of the pipe faces down. Attach each...

Page 10 - TYPICAL INSTALLATIONS; FACTORY BUILT CHIMNEY:; Wall installation; Vertical installation

TYPICAL INSTALLATIONS FACTORY BUILT CHIMNEY: ROOF FLASHING 18" CLEARANCE WALL SUPPORT WALL RADIATION SHIELD RAIN CAP Wall installation CEILING SUPPORT RADIATION SHIELD Vertical installation 9

Page 14 - WOOD STOVE UTILISATION; AVERAGE ENERGY YIELD OF ONE AIR DRIED CORD OF CUT WOOD; Wood species

13 WOOD STOVE UTILISATION Your heating unit was designed to burn wood only; no other materials should be burnt. Wastes and other flammable materials should not be burnt in your wood stove. Any type of wood may be used in your stove, but specific varieties have better energy yields than others. Pleas...

Page 15 - under supervision; , in order to allow for good combustion. After this time, you

14 Smaller pieces of wood will dry faster. All logs exceeding 6" in diameter should be split. The wood should not be stored directly on the ground. Air should circulate through the cord. A 24" to 48" air space should be left between each row of logs, which should be placed in the sunnies...

Page 16 - ASH DISPOSAL

15 ASH DISPOSAL Ashes should be removed from the stove every few days or when ashes get to 2 to 3 inches deep. Always empty the stove when it is cold, such as in the morning. Always dispose of ashes in a metal container with a tight fitting lid. Place this container on a non combustible floor or on ...

Page 17 - AIR CIRCULATION SYSTEM; (49°C) and cut off power when the stove cools down below 100; MAINTENANCE; GLASS; The glass should be washed only when cold.; GASKETING

16 AIR CIRCULATION SYSTEM In order to improve air circulation in the room where the wood stove is installed, certain options are available for specific stove models. Blower: A variable speed-control blower is available. The part number is AC02050. Thermodisc: The thermodisc is installed on the blowe...

Page 18 - PAINT; F heat resistant paint. For this purpose, simply; WHEN DO I NEED TO REPLACE THE FIREBRICKS?; your stove would wear out prematurely. It could also; REPLACEMENT PARTS; Replacement parts can be located on our web site at

17 WARNING: • N EVERS OPERATE THE STOVE WITHOUT A GASKET OR WITH A BROKEN ONE . D AMAGE TO THE STOVE OR EVEN HOUSE FIRE MAY RESULT PAINT Only clean your stove with a dry soft clothe that will not harm the paint finish. If the paint becomes scratched or damaged, it is possible to give your wood stove...

Page 19 - DROLET LIMITED LIFETIME WARRANTY

18 DROLET LIMITED LIFETIME WARRANTY The warranty of the manufacturer extends only to the original consumer purchaser and is not transferable. This warranty covers brand new products only, which have not been altered, modified nor repaired since shipment from factory. Proof of purchase (dated bill of...

Drolet DB03060 - Manual

Table of Contents:

Summary

Other Drolet Models