Drolet ALASKA 2000 - Manual

Page 2 - TABLE OF CONTENT; TECHNICAL DATA; HIMALAYA OIL BURNING STOVE

TABLE OF CONTENT TECHNICAL DATA ......................................................................................................................................... 1 INSTALLATION INSTRUCTIONS .........................................................................................................

Page 3 - INSTALLATION INSTRUCTIONS; LOCATING THE STOVE

INSTALLATION INSTRUCTIONS LOCATING THE STOVE • Install the stove as close to the chimney as possible. • Many configuration are possible, the most frequent are illustrated in figures 1,2 and 3. • Respect clearances indicated on page 1. They have been tested according to approvals. • Always respect cl...

Page 4 - CHIMNEY INFORMATIONS

CHIMNEY INFORMATIONS • Before the hook up of the stove, check if the chimney is in good condition and that the quality of the flue will allow a sufficient draught. For a good combustion, refer to the technical data of the stove to know the minimum draught required. • Factory built a type chimney or ...

Page 5 - CONNECTING THE STOVE TO THE CHIMNEY

CONNECTING THE STOVE TO THE CHIMNEY • The gases are vented from he back of the unit. The female part of the black pipe connector has to be installed toward the flue connector of the stove. Secure all connections with the (3) self taping screws, with 120 o distance between each of them. • The connect...

Page 6 - LEVELING THE UNIT; FIXATION OF STOVE TO FLOOR

LEVELING THE UNIT • Now that the stove is in place and properly hooked up to the chimney, you have to adjust the level on the burner. • Put the level in the middle of the burner paralleled to the door. (Figure 9A). Screw or unscrew the adjustable legs to level the burner with a 7/16" key. • Put ...

Page 7 - CONNECTING STOVE TO OIL TANK

CONNECTING STOVE TO OIL TANK • Make sure that the tank outlet is 12" higher than the inlet of the carburetor. (Gravity fed) • Use only caper piping to connect tank to stove. • Make sure that there is a small slope on the connection from the tank toward the stove. • A 3" down slope is needed ...

Page 9 - OPERATION INSTRUCTIONS

OPERATION INSTRUCTIONS COMBUSTIBLE • Your stove has been design to work with oil #1 or #2. DO NOT USE GASOLINE, CRANKCASE OIL OR ANY OIL CONTAINING GASOLINE. Drolet Stoves & Fireplaces declines all responsibility regarding damage cause by using other combustibles. • Best results are obtained whe...

Page 10 - CHANGING INTENSITY

LIGHTING (CONT’D) • Place the flow regulating handle on the "1" position, as soon as the oil enters the burner return to "0" position. • Open the door and pore into the burner 2 to 3 once (75 ml) of lighting gel or wood alcohol. NOTE : USE OF LIGHTING GEL IS BETTER OF A SAFE IGNITION...

Page 11 - TURNING THE STOVE OFF; MAINTENANCE

TURNING THE STOVE OFF • Set the flow regulating handle to position 0. • If you plan to keep the stove off for a long while, it is recommended to disarm the valve’s lever and close the tap on the pipe between the stove and your oil tank. (See TOP VIEW above). ALWAYS KEEP THE VALVE SHUT OFF WHEN THE B...

Page 14 - SPARE PARTS; DESCRIPTION CODE

SPARE PARTS After years of use, if you need to replace some parts, please contact your SUPPLIER or one of our Drolet approved DEALERS. • Give him product data as displayed in your warranty voucher or on your appliance’s name plate at the rear. Keep the warranty voucher even after its EXPIRY date. • ...

Page 16 - W A R R A N T Y

W A R R A N T Y The Drolet Stoves & Fireplaces warranty applies to the original buyer only. This warranty may not be transferred to a second person and becomes effective on the date of purchase. Proof of purchase is necessary to validate the warranty and to establish the warranty coverage period...

Drolet ALASKA 2000 - Manual

Table of Contents:

Summary

Other Drolet Models