Page 2 - IMPORTANT - READ CAREFULLY; The Dixon
IMPORTANT - READ CAREFULLY The Dixon s ZTR,-, Mower is both easy and fun to operate. However, any power mower must be operated properly to be safe. It is not a toy or a recreational vehicle. Before you start to use the mower, read the operator's manual carefully, and become completely familiar with ...
Page 3 - INDEX
Part No. 8920 October 1997 MY98 INDEX SAFETY................................................................ Pages 1 - 6 WARRANTY POLICY ........................................... Page 7 SPECIFICATIONS ................................................ Pages 8 - 1 0 SEAT ADJUSTMENT .....................
Page 4 - The most common causes of injury to the operator or bystander...
RIDING LAWNMOWERS, IF IMPROPERLY OPERATED, CAN CAUSE SERIOUS INJURY OR DEATH The most common causes of injury to the operator or bystander... Page 1
Page 5 - SAFETY ALERT SYMBOL -; will
SAFETY SYMBOLS: SAFETY ALERT SYMBOL - When you see this symbol, BE ALERT to the potential for injury. Follow recommended safety precautions and safe operating practices. Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. Warning indicate...
Page 6 - serious injury or death.
This cutting mower is capable of amputating hands and feet, and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. GENERAL OPERATION: • Read, understand, and follow all instructions in the manual and on the mower before starting. • Only al...
Page 7 - DO NOT
SLOPE OPERATION: Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it. DO Mow across the slope with your Dixon ZTR - never ...
Page 8 - • Be alert and turn mower off if a child enters the area.
CHILDREN: Tragic accidents can occur if the operator is not alert to the presence of children. Children are attracted to lawn mowers and the mowing activity. NEVER assume children will stay where they were last seen. Be alert to avoid accidents. • Keep children out of the mowing area and under the w...
Page 10 - DIXON PROTECTION PLUS TWO YEAR LIMITED WARRANTY POLICY
DIXON PROTECTION PLUS TWO YEAR LIMITED WARRANTY POLICY This warranty policy applies to all (30"), (36"), (42") mowers purchased on or after March 1, 1990. WARRANTY: The Dixon Protection Plus Warranty term is for a period of two (2 ) years from date of purchase. DIXON ZTR MOWERS ARE WARRA...
Page 11 - SPECIFICATIONS; SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
SPECIFICATIONS Model ZTR 3303 CHASSIS: The monocoque design chassis of the 3000 Series Models incorporates CMC Laser and CNC brake processes to form the twin 12 gauge side frames and 7 gauge transmission and engine base plate. BODY: All body parts are made of rotational molded polyethylene. Front bo...
Page 14 - SEAT ADJUSTMENT INSTRUCTIONS; Raise and push seat assembly forward.
SEAT ADJUSTMENT INSTRUCTIONS Models ZTR 3303 - ZTR 3304 - ZTR 3014 1. Raise and push seat assembly forward. 2. Loosen five nuts, P/N 3205, and slide seat forward or backward to desired position. 3. Re-tighten nuts, P/N 3205. DO NOT operate mower without seat adjustments properly tightened. 4. Push s...
Page 16 - CONTROLS; fingertip; TO SET PARKING BRAKE:
CONTROLS The Dixon ZTR has a unique transaxle that requires only two drive levers to control braking, turning, speed, and direction. On initial operation, set throttle speed on slow and operate with mower blade "OFF". To avoid "over-controlling" the mower, use a light touch on the dr...
Page 17 - TWIN FUNCTION THROTTLE CONTROL LEVER:
CONTROLS: TO GO FORWARD: From neutral position, gently push both drive levers forward. To increase speed, move levers farther forward. TO GO BACKWARD: From neutral position, gently pull both drive levers toward you. TURNING: Turning is controlled by moving one drive lever slightly forward or rearwar...
Page 18 - Located to left of operator.; slowly; BLADE DRIVE: Model ZTR 3014; To engage the mower blades, lift switch up; MOWER DECK CUT HEIGHT LIFT LEVER:
CONTROLS: BLADE DRIVE: Models ZTR 3303 - ZTR 3304 Located to left of operator. To engage the mower blade, turn lever on floor slowly to the "ON" position. To disengage mower blade, turn lever to the "OFF position. BLADE DRIVE: Model ZTR 3014 Located on control panel, on operator's right....
Page 19 - OPERATION INSTRUCTIONS; NEVER; BEFORE OPERATING MOWER:
OPERATION INSTRUCTIONS The safe and successful operation of the 3000 Series Models will depend upon the operator having the correct knowledge of all controls used on the mower and making good judgements about the terrain to be mowed. NEVER allow anyone to operate the mower without complete knowledge...
Page 20 - PARKING BRAKE SWITCH TEST:; With parking brake in the OFF position,; BLADE DRIVE SWITCH TEST:; a. With either electric blade drive switch
OPERATION INSTRUCTIONS PARKING BRAKE SWITCH TEST: With parking brake in the OFF position, engine should not turn over or attempt to start when the key switch is moved to the start position. BLADE DRIVE SWITCH TEST: (Electric Clutch or Manual Drive) a. With either electric blade drive switch turned o...
Page 21 - STARTING INSTRUCTIONS:; MAXIMUM or wide open setting to insure adequate cooling of the
OPERATION INSTRUCTIONS STARTING INSTRUCTIONS: 1. Move throttle control to "Choke" position if engine is cold, full throttle if warm. 2. Insert ignition key and turn to "Start" position. When engine starts, release ignition key. Key will return to "Run" position. 3. Move throt...
Page 22 - MOWING WITH A MULCHING ATTACHMENT:; Do Not Attempt To Cut Grass When It Is Wet.
OPERATION INSTRUCTIONS MOWING WITH A MULCHING ATTACHMENT: Mulching or recycling the grass clippings requires a totally different mowing approach than would be normal when side discharging or bagging the grass. There may be instances or conditions where it is not possible to hide all of the recycled ...
Page 23 - MOWING WITH A GRASS CATCHER ATTACHMENT:
OPERATION INSTRUCTIONS MOWING WITH A GRASS CATCHER ATTACHMENT: In order to achieve optimum performance when mowing with a grass catching attachment, please read and follow the tips listed below. 1. Set engine speed control to the wide open or full setting. 2. Do Not Attempt To Cut Grass When It Is W...
Page 24 - SIDE DISCHARGE OF THE CLIPPINGS:; GRASS HEIGHT SUGGESTIONS:; Correct mowing height can reduce weeds and disease by 50 to 80%
OPERATION INSTRUCTIONS SIDE DISCHARGE OF THE CLIPPINGS: In order to achieve optimum performance when side discharging the grass clippings, please read and follow the tips listed below. Additional information can be found in the troubleshooting guide on Page 31. Be sure that deflector is properly ins...
Page 25 - CARE AND MAINTENANCE - 3000 SERIES MODELS; MAINTENANCE SCHEDULE:
CARE AND MAINTENANCE - 3000 SERIES MODELS This portion of the 3000 Series Models owners manual deals with normal service items which can be performed by the owner. Please remember that if you are in doubt as to the correct service procedures to be followed, these and other service situations can be ...
Page 26 - CUTTER BLADE MAINTENANCE:; Observe proper blade position prior to removal.
CARE AND MAINTENANCE - 3000 SERIES MODELS CUTTER BLADE MAINTENANCE: NOTE: Observe proper blade position prior to removal. 1. Safely raise front of mower. 2. Hold or block blade from turning. Wear heavy, thick gloves when holding onto cutter blade, avoid the sharp edge of the blade. NOTE: Be sure bla...
Page 27 - Place cut height lever in lowest cut position.
CARE AND MAINTENANCE - 3000 SERIES MODELS BELT TENSION: Manual Clutch: Models ZTR 3303 & ZTR 3304: No Adjustment Electric Clutch: Model ZTR 3014-36" Deck: Adjust idler shock mount per diagram. NOTE: Model ZTR 3014-42" Deck: Belt tension maintained via spring loaded idler pulley. DECK REM...
Page 29 - Always
CARE AND MAINTENANCE - 3000 SERIES MODELS FUEL SHUT OFF VALVE: The fuel shut off valve is located at the bottom rear of the fuel tank. Always turn the valve to the "OFF" position when the mower is stored or not in use. LUBRICATION: CHASSIS: LOCATIONS: SERVICE INTERVALS: RECOMMENDED GREASE: N...
Page 30 - HOT oil may cause burns.; Push; PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS.
CARE AND MAINTENANCE - 3000 SERIES MODELS HOT oil may cause burns. Allow engine to cool before draining oil. CHANGING THE ENGINE OIL: MODELS ZTR 3303 - ZTR 3304 - ZTR 3014 1. The "snap lock" oil drain valve is located on the left side of the engine crankcase. 2. Place a suitable container un...
Page 31 - DRIVE SYSTEM ADJUSTMENTS:; performance of the drive system.; REAR CHAIN ADJUSTMENT:
CARE AND MAINTENANCE - 3000 SERIES MODELS DRIVE SYSTEM ADJUSTMENTS: Due to both the complex nature of the transmission and the number of special tools required for service, adjustments should be entrusted to your dealer. There are a number of simple owner service items which greatly influence the pe...
Page 32 - PLEASE HELP PROTECT THE ENVIRONMENT BY AVOIDING ALL
CARE AND MAINTENANCE - 3000 SERIES MODELS WHEELS AND TIRES: Correct tire pressure is important for correct operation of mower. Models ZTR 3303-ZTR 3304 Front Tires 11X4.00-5 Air Pressure 16-21 Ibs. Rear Tires 1 6 X 650 X 8 Air Pressure 8-1 4 Ibs. Model ZTR 301 4 Front Tires 11X4.00-5 Air Pressure 16...
Page 33 - STANDARD SERVICE PARTS LIST; BRIGGS & STRATTON AIR FILTER PART NUMBERS:; Protect your; Cartridge Air Cleaner:
STANDARD SERVICE PARTS LIST MODELS ZTR 3303 & ZTR 3304: BLADES: Standard: Hi-Lift: P/N 2483 P/N 2484 BELTS: Engine To Mower Deck: Engine To Transmission: P/N 7725 P/N 7650 MODEL ZTR 301 4: 36" Deck 42" Deck BLADES: Standard: Hi-Lift: P/N 1324 P/N 1351 -right side P/N 1352 -left side P/N ...
Page 34 - TROUBLESHOOTING
TROUBLESHOOTING MOWER CUT QUALITY: There are many variables that can effect the cut quality of any riding mower. Type and conditions of grass, cut height setting, engine RPM and ground speed are some of the variables that interact creating differences in cut quality. Examination of one or more of th...
Page 37 - PURCHASED FROM
OWNER INFORMATION DIXON INDUSTRIES, INC. A BLOUNT International Inc. Co. POBOX 1569 COFFEYVILLE KS 67337 0945 316251 2000 FAX 316 251 4117 DATE PURCHASED MOWER MODEL NUMBER MOWER SERIAL NUMBER DM- PURCHASED FROM Name Address DATE OIL CHANGED: DATE ENGINE TUNED:
