Dimplex KDS6401E - Manual
Dimplex KDS6401E – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – QUICK REFERENCE GUIDE FOR contempra
- Page 4 – IMPORTANT INSTRUCTIONS; PLEASE SAVE THIS USER’S GUIDE FOR FUTURE REFERENCE
- Page 5 – INSTALLATION; extension cord rated for a minimum of 1875 watts.
- Page 6 – OPERATION; Three position ON/OFF switch; When the switch is in the center position the unit is off.; HEATER THERMOSTAT CONTROL
- Page 7 – REMOTE CONTROL; To operate, push the ON button to turn fireplace on, push the; BATTERY REPLACEMENT; Close the batter cover.; CAUTION
- Page 8 – contempra; SURFACE CLEANING; Use warm water only to clean painted surfaces of the contempra; . Do not use abrasive; TO REPLACE THE LIGHT BULBS; On the back of the contempra; remove the screws from the light access cover.; HELPFUL HINTS
- Page 9 – ONE YEAR LIMITED WARRANTY; for
PRACTICAL USER’S GUIDE
FOR THE contempra
ef
STOVE
Valued Customer,
We are pleased that you have chosen to purchase an electric stove manufactured by
Dimplex North America Limited.
7205040100REV05
Quality checked by:
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
QUICK REFERENCE GUIDE FOR contempra ef 1. Prior to the first use of the contempra ef verify the following: • Are the circuit breakers for the unit on? • Are the light bulbs in your contempra ef loose? (to check, follow the instructions for replacing the light bulbs under the maintenance section of t...
IMPORTANT INSTRUCTIONS PLEASE SAVE THIS USER’S GUIDE FOR FUTURE REFERENCE When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using this contempra ef ...
NOTE A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit...
