Dimplex BF33ST/DX - Manual

Dimplex BF33ST/DX

Dimplex BF33ST/DX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
Page: / 24

Table of Contents:

  • Page 3 – WARNING; If wiring unit to operate with; (see Section C for factory setting wiring)
  • Page 4 – SECTION A: FRAMING; Dimensions; use two conductor, non-metallic sheath cable with ground wire (3; RECOMMENDED WIRE AND FUSING REQUIREMENTS; Rough-in corner framing; Firebox dimensions
  • Page 5 – FIGURE 1; FIGURE 3
  • Page 6 – FACTORY SETTING WIRING; The unit is factory configured for 208/240 volt operation; 40 VOLT INSTALLATION; FIREPLA; POWER
  • Page 7 – 20 VOLT INSTALLATION; that all connections are tight.
  • Page 8 – 20 VOLT INSTALLATION (NO HEAT INSTALLATION)
  • Page 9 – should not; 40 VOLT INSTALLATIONS
  • Page 10 – WALL
  • Page 11 – MAIN POWER WALL SWITCH WIRING; 20 VOLT INSTALLATIONS
  • Page 15 – Before installing the unit complete the following:
  • Page 16 – FIREPLACE JUNCTI
  • Page 17 – WALL MOUNTED THERMOSTAT WIRING
  • Page 19 – FLAME OVERRIDE SWITCH WIRING; NOT AVAILABLE WITH NO HEAT INSTALLATION
  • Page 23 – WIRING SCHEMATIC
Loading the manual


INSTALLATION GUIDE FOR THE

ELECTRIC FIREPLACE


MODEL NUMBERS:

BF33ST/DX
BF39ST/DX
BF45ST/DX











7206350200REV06

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - WARNING; If wiring unit to operate with; (see Section C for factory setting wiring)

LISTINGS AND CODE APPROVALS The BF series fireplaces have been tested in accordance with the UL 2021 and CSA C22.2 No. 46 standards for fixed and location-dedicated electric room heaters. MODEL SPECIFICATIONS Model Number Description Voltage Volts Rated Power Watts Remote Control Wall Thermostat Ref...

Page 4 - SECTION A: FRAMING; Dimensions; use two conductor, non-metallic sheath cable with ground wire (3; RECOMMENDED WIRE AND FUSING REQUIREMENTS; Rough-in corner framing; Firebox dimensions

WARNING Ensure method of installation does NOT obscure the air intake slots on bottom front of unit in any manner. (see diagram in Section A) SECTION A: FRAMING Dimensions This fireplace is a zero clearance design. No combustibles can be placed on the top surface of the fireplace. Combustibles may b...

Page 5 - FIGURE 1; FIGURE 3

VOLTAGE SELECTOR SWITCH LOCATION IMPORTANT: Ensure that the incoming power supply voltage matches the setting of the voltage selector switch. NOTE: The voltage selector switch is located inside the exhaust panel on the top right hand corner. CAUTION: When changing the voltage selector switch from 24...

Other Dimplex Models

All Dimplex Other