Dimplex 6903950000 - Manual

Page 4 - IMPORTANT INSTRUCTIONS; Read all instructions before using the Sahara

1 IMPORTANT INSTRUCTIONS RETAIN THIS USER’S GUIDE FOR FUTUREREFERENCEWhen using electrical appliances, basic precautionsshould always be followed to reduce the risk of fire,electric shock, and injury to persons. 1. Read all instructions before using the Sahara fireplace. 2. The heater is hot when in...

Page 5 - fire, electric shock or injury to persons.

2 8. Do not run the cord under carpeting. Do not cover cord with throw rugs, runners, or thelike. Arrange cord away from traffic area andwhere it will not be tripped over. 9. To disconnect the unit, turn the controls off, then remove the plug from the outlet. 10. Do not insert or allow foreign objec...

Page 6 - SAVE THESE INSTRUCTIONS

3 19. Disconnect all power supply before performing any cleaning, maintenance or relocation of theunit. 20. When transporting or storing the unit and cord, keep in a dry place, free from excessivevibration and store so as to avoid damage 21 If the power supply cord is damaged, it must be replaced by...

Page 7 - Select an appropriate location to mount the

4 regulations to reduce the risk of fire, electric shockand injury to persons.Do not attempt to wire your own new outlets orcircuits. To reduce the risk of fire, electric shock orinjury to persons, always use a licensed electrician.WARNINGThe supplied mounting bracket is designed foruse with Dimplex...

Page 8 - WARNING; The wall-mounting bracket must be mounted; Figure 1

5 NOTE: It is recommended that the bottom of theunit not be mounted higher than 40" from theground (mounting bracket no higher than 62"). WARNING Ensure the front of the installed unit will be at least 3 feet (0.9m) from combustible materials, such as furniture, pillows, bedding, papers, clo...

Page 9 - Figure 4

6 5. Adjust the wall-mounting bracket so the bubble on the level is centered between the two blacklines. 6. Mark 5 other mounting screw locations, on the wall, ensuring that the wall bracket stays level. 7. Install the supplied wall anchors on the marked locations by placing a #2 phillips screwdrive...

Page 10 - Figure 7

7 3 2 1 Figure 5 12. Mount the unit on the wall as shown (Figure 6). Figure 6 Wall Bracket Supports Wall Bracket 15. 13. Fix the unit in place by inserting 2 screws through 2 ofthe 4 available back panel holes, and into the wall studs. Ifstuds are unattainable please use wall anchors. (Figure 7). Fi...

Page 11 - OPERATION; Figure 8

8 OPERATION The controls are located on the bottom surface of the Saharafireplace on the right side. Control Location Bottom View Front View A. MAIN ON/OFF SWITCH The switch has two ON positions marked withand “Manual”.The “Manual” position is for manual operation. Inthis position the built-in remot...

Page 12 - C. HEATER THERMOSTAT CONTROL

9 C. HEATER THERMOSTAT CONTROL To adjust the temperature to your individualrequirements, turn the thermostat control clockwiseall the way to turn on the heater. When the roomreaches the desired temperature, turn thethermostat knob counter clockwise until you hear aclick. Leave in this position to ma...

Page 13 - REMOTE OPERATION; Figure 9

10 REMOTE OPERATION The Fireplace is supplied with an integrated on/offremote controlNote: Ensure that the fireplace 3 positionswitch is set to the remote Control setting. (Upposition)To operate, push the ON button to turn fireplace on,push the OFF button to turn the fireplace off.BATTERY REPLACEMEN...

Page 14 - MAINTENANCE

11 MAINTENANCE WARNINGDisconnect power before attempting anymaintenance or cleaning to reduce the risk of fire,electric shock or damage to persons. LIGHT BULB REPLACEMENTAllow at least 5 minutes for light bulbs to cool beforetouching bulbs to avoid accidental burning of skin.Light bulbs need to be r...

Dimplex 6903950000 - Manual

Table of Contents:

Summary

Other Dimplex Models