Diamond Audio D6 700.4 - Manual

Page 2 - Please Practice Safe Sound!; All Diamond Audio D6 Series Amplifiers Feature:

2 Congratulations! Thank you for choosing a Diamond Audio Technologies D6 Series amplifier. We sincerely believe that D6 amplifiers have the very best performance and value. DAT products are engineered and produced with the highest quality materials and incorporate the latest technology. We think yo...

Page 4 - Connections and Controls; D6 Amplifiers; D6 Amplifiers

4 D6 Amplifiers 245 x 74mm D6 700.4 D6 1000.2 D6 1200.1 D6 2000.1 D6 450.2 25A 25A 25A 25A 25A 25A 30A 30A 30A 30A 30A 30A 30A HP LP FR F FLAT LF RF L R RR LR L R L R LOW HIGH GAIN MIN MAX BASS BOOST 0dB +18dB HPF 30Hz 500Hz LPF 30Hz 500Hz SUB SONIC 10Hz 100Hz LPF 30Hz 500Hz SUB SONIC 10Hz 100Hz LPF...

Page 6 - Installation Guidelines; Tools and Supplies

6 Installation Guidelines Tools and Supplies Listed below are the tools and supplies needed to complete this installation: • Volt/Ohm Meter • Wire strippers and wire cutters • #2 Phillips screwdriver • Battery post wrench • Hand held drill w/assorted bits • High quality electrical tape or heatshrink...

Page 7 - Mounting Locations; Vehicle Electrical System Requirements; Wiring the Amplifier

7 Mounting Locations Engine Compartment Never mount this unit in the engine compartment. Mounting the unit in the engine compartment will void your warranty. Trunk Mounting Mounting the amplifier vertically will provide adequate cooling of the amplifier. If you will be mounting it to an existing pan...

Page 8 - OR

8 3) Trim the power cable within 18 inches (45.7mm) of the positive battery post and splice in a in-line fuse holder. DO NOT install the fuse at this time. 4) Strip 1/2 inch (12.7mm) from the battery end of the power cable and crimp a large ring terminal to the cable. Connect the ring terminal to th...

Page 9 - Connecting Multiple Speakers

9 Connecting Multiple Speakers If you must connect more than one speaker per channel, there are two methods in which to do so: Series or Parallel. Parallel connections are harder on the amplifier than series connections, as the total impedance is lower compared to driving a single speaker, and the a...

Page 10 - Installing the Remote Level Controller

10 Installing the Remote Level Controller The D6 1200.1 comes packaged with a remote level control. This allows you to control the level by attenu- ating the amplitude or increasing (up to the maximum set-point) of the amplifier’s input gain control. This control does not add additional bass boost, ...

Page 11 - Troubleshooting

11 Adjustment of Built-In Crossover (All Models) Placing the switch in the HP position sets the amplifier to the High Pass mode, enabling frequencies above the cutoff point to pass. Placing the switch in the LP position sets the amplifier to the Low Pass mode, enabling frequencies below the cutoff p...

Page 12 - Diamond Audio Warranty

041807 Diamond Audio Warranty Diamond Audio Technologies, LLC (DAT) warrants this product to be free from defects in mate- rial and workmanship for a period of one (1) year from the original date of purchase provided it was purchased from an authorized DAT retailer within the United States. However,...

Diamond Audio D6 700.4 - Manual

Table of Contents:

Summary

Other Diamond Audio Models