Dewalt SS200- User Manual

Page 2 - GENERAL SAFETY RULES

2 GENERAL SAFETY RULES Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with the operation of the product. Using the machine with respect and caution willconsiderably lessen the possibility of personal inj...

Page 3 - SAVE THESE INSTRUCTIONS.

3 ADDITIONAL SAFETY RULES FOR SCROLL SAWS WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY. SAVE THESE INSTRUCTIONS. Refer to them often and use them to instruct others. 1. DO NOT OPERATE THIS MACHINE until it is assembled and installed according to the instructions. 2. O...

Page 5 - EXTENSION CORDS; OPERATING INSTRUCTIONS; FOREWORD; UNPACKING AND CLEANING; NOTICE: THE MANUAL COVER PHOTO ILLUSTRATES THE CURRENT; SCROLL SAW PARTS

Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug and matchingreceptacle which will accept the machine’s plug. Whenusing an extension cord, be sure to use one heavyenough to carry the current of the mac...

Page 6 - ASSEMBLY

6 ASSEMBLY WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTIONMANUAL. Fig. 5 Fig. 6 Fig. 7 Fig. 8 T R I J I 1. Remove the blade from the upper blade holder. (See the section “ CHANGI...

Page 7 - OPERATING CONTROLS AND ADJUSTMENTS

7 6. Re-attach blade to upper blade holder. (See the section “ CHANGING BLADES ”, begin with instruction #6). 7. Assemble table insert (C) Fig. 9, in table as shown. NOTE: Opening in table insert (C) should be positioned toward the front for normal work with the table in thelevel position and should...

Page 10 - TILTING THE TABLE; ADJUSTING THE TABLE

10 TILTING THE TABLE The table (A) Fig. 20, on your scroll saw can be tilted upto 45 degrees to the left for bevel cutting operations. 1. Turn the table insert 90 degrees to the right. NOTE: ROTATE THE TABLE INSERT (B) FIG. 20A, TO ALLOWYOU TO TILT THE TABLE WITHOUT BENDING ORBREAKING THE BLADE. 2. ...

Page 11 - FOLLOWING A LINE; INSIDE CUTTING

11 ADJUSTINGHOLDDOWN The bottom of the holddown (A) Fig. 24, should beadjusted so it contacts the top surface of the work beingcut by loosening lock handle (B) and moving holddownassembly (C) up or down. Then tighten lock handle (B). NOTE: Lock handle (B) is spring-loaded and can be repositioned by ...

Page 12 - MAINTENANCE; LUBRICATION

12 MAINTENANCE LUBRICATION Perform maintenance below after each 20 hours of use. 1. DISCONNECT MACHINE FROM POWER SOURCE. 2. Remove the four screws (A) Fig. 26, and side panel (B). 3. Release blade tension by moving blade tension lever to the vertical position. 4. Remove the two pivot bolts and wave...

Page 14 - Two Year Limited Warranty; PARTS, SERVICE OR WARRANTY ASSISTANCE

Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin normal use has proven to be defective in workmanship or material, provided that the customer returns the productprepaid to a Delta factory service c...

Table of Contents:

Summary

Other Dewalt Models