Dewalt N090451- Manual

Page 3 - SAVE ALL WARNINGS AND INSTRUCTIONS FOR

1 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING: Indicate...

Page 5 - MINIMUM GAUGE FOR CORD SETS; ADDITIONAL SAFETY INSTRUCTIONS FOR PLANERS; areas with soap and water.

3 MINIMUM GAUGE FOR CORD SETS For Cable length (m): 7.5 15 25 30 45 60 Use Cable with minimum rating (Amperes)Tool Amperes 0 - 3.4 7.5 7.5 7.5 7.5 7.5 7.5 3.5 - 5.0 7.5 7.5 7.5 7.5 10 15 5.1 - 7.0 10 10 10 10 15 15 7.1 - 12.0 15 15 15 15 20 20 12.1 - 20.0 20 20 20 20 25 – ADDITIONAL SAFETY INSTRUCTI...

Page 6 - OPERATION; installing attachments or accessories.; Motor; never; Introduction

4 Components (Fig. 1) A. Trigger switch E. Shoe B. Lock-on button F. Rabbet fence (not shown) C. Depth adjustment knob/front handle G. Rabbet fence adjustment knob D. Switch Handle H. Chip discharge chute C FIG. 1 B A G E D H G OPERATION WARNING: To reduce the risk of serious personal injury, turn t...

Page 7 - Allow the tool to reach full speed before touching tool to the work; removing/installing attachments or accessories.; Allow the tool to reach full speed before touching tool to the work

5 CAUTION: Allow the tool to reach full speed before touching tool to the work surface. Lift the tool from the work surface before turning the tool off. To star t the planer depress the trigger switch (A). To turn the planer off, release the trigger switch. Adjusting Planing Depth (Fig. 1) WARNING: ...

Page 8 - desired position then securely tighten rabbet fence knob.; Reversible Carbide Blades; To Remove Blade from Planer

6 To Install Rabbet Fence 1. Loosen the rabbet fence adjustment knob (G). 2. Slide the crossbar on the rabbet fence (F) into the hole near the front of the planer as shown in Figure 5. 3. Securely tighten rabbet fence adjustment knob (G) as shown in Figure 6. 4. The rabbet fence should be below the ...

Page 9 - To Reinstall Blade; High-speed Steel Blades; MAINTENANCE; turn unit off and disconnect tool from

7 d. Simultaneously push the blade carrier (L) and the guide bar (M) into the gauge plate inside wall (O), making sure that the carbide blade (I) is held firmly against the gauge plate inside wall (O) and securely tighten the two hex screws (P). 3. To Reinstall Blade a. Remove the adjusted blade car...

Page 10 - FREE ONE YEAR SERVICE CONTRACT; Lubrication

8 Guarantee Applicable to hand held Power Tools, Lasers and Nailers. Three Year Limited Warranty D E WALT will repair, without charge, any defects due to faulty materials or workmanship for three years from the date of purchase. Please return the complete unit, transpor tation prepaid, to any D E WA...

Page 11 - FREE WARNING LABEL REPLACEMENT:; If your warning labels become illegible or

9 FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call (AUS) 1800 654 155 or (NZ) 0800 339258 for a free replacement.

Table of Contents:

Other Manuals for Dewalt N090451

Summary

Other Dewalt Models