Dewalt DWE4001 XE - User Manual

Page 3 - SAFETY INSTRUCTIONS FOR POWER TOOLS

1 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING: Indicate...

Page 4 - GENERAL POWER TOOL SAFETY WARNINGS; SAVE ALL WARNINGS AND INSTRUCTIONS FOR

2 WARNING: To reduce the risk of injury, user must read the instruction manual. GENERAL POWER TOOL SAFETY WARNINGS WARNING! Read all safety warnings and all instructions Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term “power tool” in...

Page 6 - Further Safety Instructions for All Operations

4 q) Do not use Type 11 (flaring cup) wheels on this tool. Using inappropriate accessories can result in injury. r) Always use side handle. Tighten the handle securely. The side handle should always be used to maintain control of the tool at all times. STANDARD WHEEL DIMENSIONS Wheel Type Wheel dime...

Page 8 - Additional Specific Safety Warnings for Grinders

6 b) If the use of a guard is recommended for wire brushing, do not allow any interference of the wire wheel or brush with the guard. Wire wheel or brush may expand in diameter due to work and centrifugal forces. Additional Specific Safety Warnings for Grinders • Check that the grinding wheel backin...

Page 9 - INTENDED USE; ASSEMBLY AND ADJUSTMENTS

7 …/min .............per minute .......................safety aler t symbol BPM .................beats per minute IPM .....................impacts per minute RPM .................revolutions per minute SPM ....................strokes per minute sfpm ................surface feet per minute SAVE ALL W...

Page 10 - Grinding and Cutting Accessory Chart

8 Attaching Side Handle (Fig. 1) WARNING: Before using the tool, check that the handle is tightened securely. Screw the side handle (C) tightly into one of the holes on either side of the gear case. The side handle should always be used to maintain control of the tool at all times. Accessories and A...

Page 12 - Wear work gloves when handling wire brushes and wheels.

10 4. With the spindle facing the operator, rotate the guard clockwise into the desired working position. The guard body should be positioned between the spindle and the operator to provide maximum operator protection. 5. For easy adjustment, the guard can be rotated in the clockwise direction. NOTE...

Page 13 - Switches

11 • Apply only a gentle pressure to the tool. Do not exer t side pressure on the disc. • Avoid overloading. Should the tool become hot, let it run a few minutes under no load condition. Proper Hand Position (Fig. 1, 4) WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand p...

Page 14 - Metal Applications; Maintenance; Using Flap Discs

12 SWITCHING ON AND OFF (FIG. 4) WARNING: Before using the tool, check that the handle is tightened securely. To turn on the tool, lift up the button (G) to "1" position. To turn off the tool, push the toggle switch button (G) to the "0" position. WARNING: Do not switch the tool on o...

Dewalt DWE4001 XE - User Manual

Table of Contents:

Summary

Other Dewalt Models