Dewalt DCB106 XE - User Manual

Page 4 - SAVE ALL WARNINGS AND INSTRUCTIONS FOR

2 accessories or poorly maintained, the vibration emission may differ. This may significantly increase the exposure level over the total working period. An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but...

Page 5 - Electrical Safety

3 d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating par t of the power tool may result in personal injury. e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpecte...

Page 6 - Extension Cords

4 WARNING: ALWAYS wear approved protective safety equipment complying with the following standards: • Eye protection: AS/NZS1337 Eye Protectors for Industrial Applications;• Hearing protection: AS/NZS1270 Acoustics – Hearing Protection;• Respiratory protection: AS/NZS1716 Respiratory Protective Devi...

Page 7 - Important Safety Instructions for All Battery Packs; READ ALL INSTRUCTIONS

5 min ..................minutes or AC ............alternating current or DC .....direct current or AC/DC ......alternating or ...................Class I Construction ........................... direct current (grounded) no .......................no load speed ...................Class II Construction...

Page 9 - Indicator Light Operation; PACK CHARGING; Charge Indicators; LEAVING THE BATTERY PACK IN THE CHARGER; Important Charging Notes

7 3. The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully charged and may be used at this time or left in the charger. Indicator Light Operation DCB106-XE PACK CHARGING PACK CHARGED DCB107-XE PACK CHARGING PACK CHARGED HOT/COLD DELAY Charge Indicat...

Page 10 - ASSEMBLY AND ADJUSTMENTS; attachments or accessories.; Storage Recommendations; INTENDED USE

8 A B C FIG. 2 D F E H G DCD771-XE I ASSEMBLY AND ADJUSTMENTS WARNING: To reduce the risk of serious personal injury, turn the tool off and disconnect the battery pack before making any adjustments or removing/installing attachments or accessories. An accidental star t-up can cause injury. Variable ...

Page 12 - OPERATION

10 Be sure to tighten chuck with one hand on the chuck sleeve and one hand holding the tool for maximum tightness.To release the accessory, repeat steps 1 and 2 above. OPERATION WARNING: To reduce the risk of serious personal injury, turn the tool off and disconnect the battery pack before making an...

Page 13 - To reduce the risk of personal injury, ALWAYS; RELEASE TRIGGER IMMEDIATELY,; MAINTENANCE

11 WARNING: To reduce the risk of personal injury, ALWAYS ensure workpiece is anchored or clamped firmly. If drilling thin material, use a wood “back-up” block to prevent damage to the material. 1. Turn the collar (C) to the drill symbol. 2. Select the desired speed/torque range using the gear shift...

Page 14 - CHARGER CLEANING INSTRUCTIONS; Repairs

Lubrication Your power tool requires no additional lubrication. Cleaning WARNING: Blow dir t and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear AS/NZS1337 approved eye protection when performing this. WARNING: Never use solvents or...

Dewalt DCB106 XE - User Manual

Table of Contents:

Summary

Other Dewalt Models