Dewalt D55570- User Manual

Dewalt D55570

Dewalt D55570– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
Page: / 63

Table of Contents:

  • Page 5 – SPECIFICATIONS
  • Page 6 – SAVE THESE INSTRUCTIONS; Safety Instructions; WARNING: Some dust created by this product contains chemicals
  • Page 7 – compressor with guar ds or protective covers that are damaged or
  • Page 8 – REPAIR OR REPLACE DAMAGED OR WORN CORDS IMMEDIATELY.; RISK FROM NOISE; CAUTION: Wear appropriate personal hearing
  • Page 9 – Introduction; Congratulations on the purchase of your new D; Inspection of Compressor; DUAL VOLTAGE; WA LT compressor unloads through
  • Page 10 – removed or modified in any way.; Common Procedures; Ensure that cord requirements have been met.
  • Page 11 – WA LT for proper procedures to install the plug.; MOTOR REQUIREMENTS; UNITS WITHOUT A DUAL VOLTAGE SWITCH
  • Page 12 – CHECKING COMPRESSOR PUMP OIL LEVEL; pump oil if contaminants are present.
  • Page 14 – . Move compressor into an inclined position so drain valve(s) are at; Preparation For Use; C A U T I O N : Do not operate without lubricant or with inadequate; Compatibility; C A U T I O N : In order to avoid damaging the air compressor, do not
  • Page 15 – WARNING: Ensure proper footing and use caution when rolling; Air Inlet Filter; C A U T I O N : Do not operate without air inlet filter; General Requirements; prevent air leaks. DO NOT USE PVC PLASTIC.; Operating Procedures; e l i m i n a t e d .
  • Page 16 – Maintenance; Year or; WA LT synthetic oil, change oil every 200
  • Page 17 – CHECKING BELT TENSION; WA R N I N G : A f t e r c o o l e r, pump head, and surrounding parts are very; ADJUSTING BELT TENSION; WA R N I N G : Pump and surrounding components are hot.; Accessories; Recommended accessories for use with your tool are available for
  • Page 18 – Service Information; WA LT heavy duty industrial tools are warranted for one year from
  • Page 19 – TROUBLESHOOTING GUIDE; P r o b l e m
  • Page 24 – CARACTÉRISTIQUES TECHNIQUES
  • Page 25 – AV E RT I S S E M E N T ! Lire et comprendre toutes les directives; CONSERVER CES INSTRUCTIONS; Consignes de sécurité; AV E RT I S S E M E N T: Une partie de la poussière créée par ce produit
  • Page 27 – retirés. Ne jamais se tenir debout sur le compresseur.; SURFACES CHAUDES; MISE EN GARDE : porter un dispositif de protection personnel; DIAGRAMME DES RALLONGES; C a l i b r e
  • Page 28 – Se renseigner auprès d'un électricien compétent ou du personnel; WA LT! Nous tenons à vous assurer que cet appareil a été construit
  • Page 29 – WA LT se décharge par la tête de compresseur
  • Page 30 – constant d’air pur, frais et sec, ce filtre doit; Procédures courantes :
  • Page 31 – APPAREILS MUNIS D’UN INTERRUPTEUR BITENSION; . Tourner le bouton situé sur le dessus du robinet pilote (H) vers la
  • Page 32 – REMARQUE : pour que l’appareil fonctionne correctement, le point de; la pompe commence à alimenter les réservoirs d’air.
  • Page 33 – VÉRIFICATION DE L’ÉLÉMENT DU FILTRE À AIR; AV E RTISSEMENT : le refroidisseur complémentaire, la tête de; RÉGLAGE DU RÉGULATEUR; INSTALLATION DES BOYAUX; AV E RTISSEMENT : saisir fermement le boyau pour l’installer ou le
  • Page 34 – DÉSACCOUPLEMENT DES BOYAUX; PURGE DES RÉSERVOIRS; AV E RTISSEMENT : les réservoirs contiennent de l’air à haute; Préparations avant utilisation; MISE EN GARDE : ne pas faire fonctionner le compresseur sans
  • Page 35 – Emplacement; MISE EN GARDE : pour éviter d’endommager le compresseur d’air,; TRANSPORT; AV E RTISSEMENT : le poids de l’appareil est supérieur à 160 lb. Ne
  • Page 36 – FILTRE D’ADMISSION D’AIR; MISE EN GARDE : Ne jamais faire fonctionner le compresseur sans; Mode d’emploi; . Vérifier le niveau d’huile de la pompe (consulter la rubrique «
  • Page 37 – E n t r e t i e n
  • Page 38 – Réglage de la tension de la courroie; AV E RTISSEMENT : la pompe et les composants contigüs sont; Accessoires
  • Page 39 – MISE EN GARDE : l’usage d’un accessoire non recommandé peut; Réparations
  • Page 40 – Guide de Dépannage; Problème
  • Page 46 – ¡ A D V E RTENCIA! Lea y comprenda todas las instrucciones; C O N S E RVE ESTAS INSTRUCCIONES; Instrucciones de seguridad; A D V E RTENCIA: Algunos polvos generados por este producto
  • Page 47 – manómetro a la salida de aire de su compresor. Siga las
  • Page 49 – Introducción; ¡Felicitaciones por la compra de su nuevo compresor de aire D; Inspección del compresor
  • Page 51 – Procedimientos comunes; OPERACION A 230 VOLTS; Asegúrese de cumplir con los requerimientos de cable.; WA LT de su localidad, con un; UNIDADES CON INTERRUPTOR DE VOLTAJE DOBLE; A D V E RTENCIA: Asegúrese de que se haya instalado una clavija
  • Page 53 – REVISIÓN DE LA VÁLVULA DE ALIVIO DE SEGURIDAD; A D V E RT E N C I A : el disipador de calor, la cabeza de la bomba y las
  • Page 54 – REVISIÓN DEL ELEMENTO DEL FILTRO DE AIRE; AJUSTE DEL REGULADOR; A D V E RT E N C I A : Sujete la manguera con; DESCONEXIÓN DE LAS MANGUERAS; A D V E RT E N C I A : Sujete la manguera con firmeza para evitar que; DRENAJE DE LOS TANQUES; A D V E RT E N C I A : El tanque contiene aire a alta presión. Conserve
  • Page 55 – Preparación para el uso; P R E C A U C I Ó N : No opere el compresor sin lubricante o con el; Compatibilidad; P R E C A U C I Ó N : para evitar dañar el compresor de aire, no permita
  • Page 56 – TRANSPORTE; A D V E RT E N C I A : la unidad pesa más de 72 kg. No la mueva sin; Filtro de entrada de aire; P R E C A U C I Ó N : No se opere sin el filtro de entrada de aire.; Requerimientos generales; Lista de pre arranque
  • Page 57 – A D V E RT E N C I A : Asegúrese de que el compresor tenga la clavija; N O TA: si ha terminado de usar el compresor, siga los pasos 2 a 7.; Mantenimiento
  • Page 58 – Tabla de mantenimiento; A D V E RT E N C I A : el disipador de calor, la cabeza; REVISIÓN DE LA TENSIÓN DE LA BANDA
  • Page 59 – Accesorios; P R E C A U C I Ó N : El empleo de cualquier accesorio no recomendado; Reparaciones; PARA UNIDADES CON BOMBA G; A D V E RT E N C I A : La bomba y las piezas que la rodean están
  • Page 60 – WA LT más cercano o a la fábrica D
  • Page 61 – Guía para solución de problemas frecuentes; Problema
Loading the manual

D

E

WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286

(FEB03) Form No. 5134371-00 Multi Elect Air Compressors

Copyright © 2001, 2003

D

E

WA LT

The following are trademarks for one or more D

E

WA LT power tools: the yellow and black color scheme; the “D” shaped air intake grill;

the array of pyramids on the handgrip; the kit box configuration; and the array of lozenge-shaped humps on the surface of the tool.

5134371,DW55170,ElecComp 2/10/03 2:38 PM Page 2

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 5 - SPECIFICATIONS

SPECIFICATIONS MODEL WEIGHT HEIGHT WIDTH LENGTH Typical values @ 100 psiSCFM Current D55170 168 lbs. (76.20 kg.) 33.0 in. (838.2 mm) 22.5 in. (571.5 mm) 45.0 in. (1143.0 mm) 6.5 15 amps D55180 172 lbs. (78.02 kg.) 23.5 in. (596.9 mm) 18.25 in. (463.55 mm) 43.0 in. (1092.2 mm) 8.4 20 amps D55390 231 ...

Page 6 - SAVE THESE INSTRUCTIONS; Safety Instructions; WARNING: Some dust created by this product contains chemicals

1 AIR TANKThe tank on your Air Compressor is designed and may be UM coded(for units with tanks greater than 6 inch diameter) according to ASMESection VIII, Div. 1 rules. All pressure vessels should be inspectedonce every two years. To find your state pressure vessels inspector,look under the Divisi ...

Page 7 - compressor with guar ds or protective covers that are damaged or

2 vapors, they may ignite, causing fire or explosion. If sprayingflammable materials, locate compressor at least 20 feet up wind fromspray area. An additional length of hose may be required.Store flammable materials in a secure location away from compressor.Restricting any of the compressor ventilat...

Other Dewalt Models

All Dewalt Other