Dewalt D28065 XE - User Manual

Page 3 - SAVE THESE INSTRUCTIONS; Definitions: Safety Guidelines

1 IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D E WALT TOOL, CALL US AT: 1800 654 155 (Aust) or 09 259 1111 (NZ). SAFETY INSTRUCTIONS FOR POWER TOOLS When using power tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and pe...

Page 5 - Kickback and Related Warnings

3 c) Do not use accessories which are not specifically designed and recommended by the tool manufacturer. Just because the accessory can be attached to your power tool, it does not assure safe operation. d) The rated speed of the accessory must be at least equal to the maximum speed marked on the po...

Page 8 - Causes and Operator Prevention of Kickback

6 • When wheel is binding, or when interrupting a cut for any reason, release the trigger and hold the unit motionless in the material until the wheel comes to a complete stop. Never attempt to remove the unit from the work or pull the unit backward while the wheel is in motion or kickback may occur...

Page 9 - Cutting Wheels

7 125 mm (5") Cutting Wheels Type 1 guard Quick-Change wheel release Type 1 abrasive cutting wheel threaded clamp nut Type 1 guard Quick-Change wheel release diamond cutting wheel threaded clamp nut Type 27 guard 125 mm (5") Grinding Wheels Quick-Change wheel release threaded clamp nut Type ...

Page 10 - Wire Wheels; Sanding Discs

8 Wire Wheels 3” wire cup brush 4” wire wheel Type 27 guard Type 27 guard rubber backing pad sanding disc threaded clamp nut Sanding Discs 125 mm (5") Sanding Flap Discs hubbed sanding flap disc Quick-Change wheel release non-hubbed sanding flap disc threaded clamp nut Type 27 guard Type 27 guar...

Page 12 - OPERATION; installing attachments or accessories.; Guards and Flanges; NOTE

10 CAUTION: Guards must be used with all grinding wheels, sanding flap discs, wire brushes, and wire wheels. The tool may be used without a guard only when sanding with conventional sanding discs. Some D E WALT models are provided with a guard intended for use with depressed center wheels (Type 27) ...

Page 13 - Mounting and Using Depressed Center Grinding Wheels

11 2. Place wheel against the backing flange, centering the wheel on the raised section (pilot) of the backing flange. 3. While depressing the spindle lock button, thread 6.35 MM (1/4" wheels) Quick-Change wheel release Clamp Nut the clamp nut (H) on spindle. If the wheel you are installing is m...

Page 15 - Mounting and Using Cutting (Type 1) Wheels; Mounting and Using Wire Brushes

13 2. Apply minimum pressure to work surface, allowing the tool to operate at high speed. Material removal rate is greatest when the tool operates at high speed. 3. Maintain a 5 ˚ to 10 ˚ angle between the tool 5 ˚ -10 ˚ and work surface for wire cup brushes. 4. Maintain contact between the edge of ...

Page 17 - FREE ONE YEAR SERVICE CONTRACT

15 Lubrication D E WALT tools are properly lubricated at the factory and are ready for use. Repairs To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement) should be performed by cer tified service centers or other qualified service ...

Dewalt D28065 XE - User Manual

Table of Contents:

Summary

Other Dewalt Models