Dewalt D25601 XE - User Manual

Page 3 - SAVE THESE INSTRUCTIONS

1 Definitions: Safety Guidelines The definitions below describe the level of severity for each signal word. Please read the manual and pay attention to these symbols. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . WARNING: Indicate...

Page 5 - Additional Safety Instructions for Rotary Hammers

3 Additional Safety Instructions for Rotary Hammers • Wear ear protectors. Exposure to noise can cause hearing loss. • Use auxiliary handle(s) supplied with the tool. Loss of control can cause personal injury. • Hold power tools by insulated gripping surfaces when performing an operation where the c...

Page 6 - Markings on Tool; SAVE THESE INSTRUCTIONS FOR FUTURE USE

4 WARNING: ALWAYS wear proper personal hearing protection that conforms to AS/NZS1270 during use. Under some conditions and duration of use, noise from this product may contribute to hearing loss. WARNING: We recommend the use of a residual current device with a residual current rating of 30mA or le...

Page 7 - Brushes; ALWAYS; Motor; INTENDED USE; Soft Start Feature

5 Electronic Speed and Impact Control (Fig. 1, 3) The electronic speed and impact control (G) offers the following advantages: – use of smaller accessories without risk of breakage; – minimised break-out when chiselling or drilling in soft or brittle materials; – optimal tool control for precise chi...

Page 8 - Inserting and Removing SDS Max

6 FIG. 2A FIG. 2B K J Q H C L R P M C I MOUNTING IN FRONT POSITION (FIG. 2A) 1. Snap the steel ring (K) over the collar (R) behind the tool holder (M). Squeeze both ends together, mount the bush (L) and inser t the pin (Q). 2. Place the side handle clamp (J) and screw on the clamp wheel (H). Do not ...

Page 9 - TO ADJUST THE DEPTH ROD; Indexing the Chisel Position; installing attachments or accessories.

7 – when breaking or drilling in harder materials, set the dial to a high setting. FIG. 3 T G S FIG. 4A M FIG. 4B Depth Rod (Fig. 1) FIG. 5 F TO ADJUST THE DEPTH ROD 1. Push in and hold the depth rod release button (N) on the side handle. 2. Move the depth rod (O) so the distance between the end of ...

Page 10 - MAINTENANCE; removing/installing attachments or accessories.; Lubrication; Hammerdrilling

8 7. Stop the tool and remove the centerdrill. Place the core bit back into the hole and continue drilling. 8. When drilling through a structure thicker than the depth of the core bit, break away the round cylinder of concrete or core inside the bit at regular intervals. To avoid unwanted breaking a...

Page 11 - MAXIMUM CAPACITY; Guarantee; FREE ONE YEAR SERVICE CONTRACT

9 Repairs To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (including brush inspection and replacement) should be performed by cer tified service centers or other qualified service organizations, always using identical replacement par ts. ACCESSORIES WARNING: Since acces...

Dewalt D25601 XE - User Manual

Table of Contents:

Summary

Other Dewalt Models