Dewalt D25124 XE - User Manual

Page 3 - SAVE THESE INSTRUCTIONS; Definitions: Safety Guidelines

1 IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY D E WALT TOOL, CALL US AT: 1800 444 224 (Aust) or 0800 339 258 (NZ). SAFETY INSTRUCTIONS FOR POWER TOOLS When using power tools, always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and p...

Page 5 - Additional Safety Instructions for Rotary Hammers

3 Additional Safety Instructions for Rotary Hammers • Wear ear protectors. Exposure to noise can cause hearing loss. • Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. • Hold power tools by insulated gripping surfaces when performing an operation where the cut...

Page 6 - Motor; INTENDED USE; Side Handle; SAVE THESE INSTRUCTIONS FOR FUTURE USE

4 Motor Your D E WALT tool is powered by a D E WALT-built motor. Be sure your power supply agrees with the nameplate markings. Voltage decrease of more than 10% will cause loss of power and overheating. All D E WALT tools are factory tested. Components (Fig. 1–6) WARNING: Never modify the power tool...

Page 7 - Switch; VARIABLE SPEED TRIGGER

5 D25314-XE, D25315-XE FIG. 3 E D C G A B D25330-XE FIG. 4 A D F H C FIG. 1 D25123-XE, D25124-XE C B A G D F E FIG. 2 D D25213-XE A G B C E Switch To star t the rotary hammer, depress the trigger switch (D). To stop rotary hammer, release the switch. VARIABLE SPEED TRIGGER The variable speed trigger...

Page 8 - SDS Plus

6 Reversing Lever (Fig. 1–4) D25123-XE, D25124-XE, D25213-XE, D25314-XE, D25315-XE The reversing lever is used to reverse the rotary hammer for backing out screws or jammed bits. It is located above the trigger, shown in Figure 2. CAUTION: When reversing to clear jammed bits, be ready for strong rea...

Page 9 - Do not use chipping bits in this tool.; OPERATION; WARNING: To reduce the risk of personal injury, ALWAYS

7 WARNING: Burn Hazard. ALWAYS wear gloves FIG. 6 D25124-XE, D25314-XE ONLY J M L K when changing bits. Accessible metal par ts on the tool and bits may get extremely hot during operation. Small bits of broken material may damage bare hands. NOTICE: Do not use chipping bits in this tool. Using chipp...

Page 10 - MAINTENANCE; removing/installing attachments or accessories.; Lubrication; DRILLING IN METAL; Depth Rod

8 MAINTENANCE WARNING: Shock Hazard. To reduce the risk of serious personal injury, turn tool off and disconnect from power source before making any adjustments or removing/installing attachments or accessories. Lubrication Your tool was properly lubricated before leaving the factory. In from two to...

Page 11 - Guarantee; FREE ONE YEAR SERVICE CONTRACT; SPECIFICATIONS

9 MAXIMUM RECOMMENDED CAPACITIES D25123-XE, D25124-XE D25213-XE, D25314-XE, D25315-XE Masonry 26 mm (1") Steel 12.7 mm (1/2") Wood 38 mm (1-1/2") OPTIMUM CAPACITY Masonry 4 mm - 16 mm (5/32"-5/8") Guarantee Applicable to hand held Power Tools, Lasers and Nailers. Three Year Limit...

Dewalt D25124 XE - User Manual

Table of Contents:

Summary

Other Dewalt Models