Delta 78-939 - Manual
Delta 78-939 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ASSEMBLY
- Page 3 – FOR ALL FENCES
- Page 5 – REPLACEMENT PARTS
- Page 6 – PARTS, SERVICE OR WARRANTY ASSISTANCE; Biesemeyer; Two Year Limited Warranty
- Page 7 – Cut Here; Center marks for commercial fence holes
- Page 8 – THIS PAGE INTENTIONALLY LEFT BLANK\
Part No. 1341095
Dated 4-30-99
BIESEMEYER
®
MODEL NO. 78-939 CUT-OFF FENCE
For use with Biesemeyer® commercial and home shop fences, and other makes of
Biesemeyer-style fences 3-1/2” or 4” wide
The cut-off fence is shipped complete in one container. Fig 1, illustrates all components shipped.
Fig. 1
COMPONENTS
1. Drilling template (for Biesemeyer
®
fences only)
2. Clamp and bracket assembly
3. Knob assembly
4. 1/4-20 x 1” hex head bolt
5. 1/4” flat washer
6. 1/4-20 locknut
7. #10x 3/4” flat head self-tapping screw
8. 6” cut-off fence support
9. Cut-off fence board
SAFETY RULES
1.
DO NOT
use cut-off fence in ripping applications; it is
only to be used with the miter gage to perform cut-offs.
2.
ALWAYS
make certain saw fence and cut-off fence are
securely fastened before use.
3.
ALWAYS
turn the saw off and allow the saw blade to
come to a complete stop before attempting to remove
cut-off pieces.
4.
AVOID
trapping the workpiece between the fence and
saw blade. The piece of wood being cut must be past the
cut-off fence before contacting the saw blade.
1
2
3
4
5
6
7
8
9
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
ASSEMBLY DISCONNECT SAW FROM POWER SOURCE UNTILALL ASSEMBLY AND SET-UP PROCEDURES HAVEBEEN COMPLETED. FOR BIESEMEYER ® COMMERCIAL OR HOME SHOP FENCES ONLY. 1. Fold template (A) Fig. 2, on fold line and align thetemplate with the bottom of fence board (B). Using a punch,mark the fence board (B) as in...
Fig. 6 Fig. 7 Fig. 8 Fig. 9 FOR ALL FENCES 8. Using a 1/8” drill bit, drill two 1/8” pilot holes 1/2” deep atthe two marked locations on the back of cut-off fence board(F) Figs. 5 and 6. NOTE: Mark the drill bit with masking tape to act as a depth gage to prevent drilling throughfence board. 9. Alig...
5 REPLACEMENT PARTS 78-939 CUT-OFF FENCE REF.NO. PART NUMBER DESCRIPTION * 78-939 CUT-OFF FENCE, CONST OF: 1 1350066 KNOB ASSEMBLY 2 1352363 CLAMP 3 1350191 END CAP 4 1350303 1/4-20 X 1-1/2” HEX HD SCREW 5 1350295 1/4-20 X 1/2” HEX HD SCREW 6 1350077 FLAG DECAL 7 1350300 #10 X 4/4” FLAT HD SCREW 8 1...
