Dell UP3214Q Monitor- User Manual

October 2013

Statement of Volatility – Dell UP3214Q UltraSharp

CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the
problem.

The Dell UP3214Q UltraSharp Monitor contains both volatile and non-volatile (NV) components. Volatile
components lose their data immediately after power is removed from the component. Non-volatile (NV)
components continue to retain their data even after power is removed from the component. The following
NV components are present on the Dell UP3214Q system board.

Table 1.

List of Non-Volatile Components on System Board

______________

© 2013 Dell Inc.

Trademarks used in this text: Dell™, the DELL log o, Dell Precision™, OptiPlex™, Latitude™, PowerEdge™, PowerVault™,
PowerConnec t™, OpenManage™, EqualLogic™, KACE™, FlexAddress™ and Vostro™ are trademarks of Dell Inc. Intel®, Pentium®,

Description

Reference
Designator

Volatility D escription

User
Accessible
for external
data

Remedial Action (Action
necessary to prevent loss of
data)

Serial Flash
ROM
W25Q16CV

I245 / I248
/ I251

Non-volatile Flash
memory, 16M bit. To
store firmware.

No

Part place on Interface
Board, it has
hardware/software write
protected.

EEPROM
M24512

I246 / I249
/ I252

Non-volatile memory,
512k bit. To store DP
EDID, HDCP and user
adjust data.

No

Part place on Interface
Board, it has
hardware/software write
protected.

DDR3
SDRAM
NT5CB64M
16FP-DH

I225 / I226
/ I227 /
I228 / I229
/ I230

Volatile memory 1Gbit
(64Mbx16). To store video
data stream and firmware
code.

No

Part place on Interface
Board.

EEPROM
24C02

I224

Non-volatile EEPROM 2Kbit.
To store HDMI EDID data.

No

Part place on Interface
Board, it has
hardware/software write
protected.

Serial Flash
ROM
PM25LD020

I233

Non-volatile Flash ROM
2Mbit. To store firmware.

No

Part place on Interface
Board, it has software write
protected.

EEPROM
24C02

I241

Non-volatile EEPROM 2Kbit.
To store monitor DC on /
off store.

No

Part place on Interface
Board, it has software write
protected.

Serial Flash
ROM
PM25LD010

I902

Non-volatile Flash ROM
1Mbit. To store firmware.

No

Part place on Card Reader
Board, it has software write
protected.

CAUTION: All other components on the system board lose data if power is removed from the system. Primary power
loss (unplugging the power cord and removing the battery) destroys all user data on the memory (DDR3, 1067 MHz).
Secondary power loss (removing the on-board coin-cell battery) destroys system data on the system configuration
and time-of-day information.