Dell T320/T420- Manual
Dell T320/T420– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 4 – Introduction; Section 1: Cabling a PowerEdge T320 & T420 system with a CMA; Connecting the cables to the system
- Page 5 – System with cables installed; Routing the power cables through the strain reliefs
- Page 6 – Installing the CMA; Left-side mounting instructions
- Page 7 – Right-side mounting instructions
- Page 8 – Replacing a hot swap power supply with a left-side mounted CMA; Replacing a hot swap power supply with a right-side mounted CMA; Replacing a hot swap power supply
- Page 9 – Cable routing without a CMA
Greg Henderson and Jose L. Flores
Data Center Infrastructure Engineering
May 2012
Cable Routing Procedures for Dell™
PowerEdge™ T320 & T420 Systems
This Dell Technical White Paper explains the best practices for routing
and securing the cables exiting the back of the T320 & T420 systems.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Cable Routing Procedures for the Dell PowerEdge T320 & T420 Systems 4 Introduction This white paper covers recommended cable routing procedures for the Dell™ PowerEdge™ T320 & T420 systems in the following racks: • PowerEdge 2410, 4210 • PowerEdge 2420, 4220, 4820 (including wide and deep ve...
Cable Routing Procedures for the Dell PowerEdge T320 & T420 Systems 5 System with cables installed Figure 1. 1.2. Routing the power cables through the strain reliefs After you have installed the tray and cables, route the power cable(s) through the strain relief(s) located on the power supply ha...
Cable Routing Procedures for the Dell PowerEdge T320 & T420 Systems 6 1.3. Installing the CMA The CMA can be installed on either the rear right or rear left side of the rails as described in the CMA Installation Instructions . Mounting the CMA on the side that is opposite of the power supplies (...
