Page 2 - Wichtige Sicherheitshinweise
Wichtige Sicherheitshinweise 1. Bitte lesen Sie sich diese Hinweise sorgfältig durch. 2. Heben Sie diese Anleitung für den spätern Gebrauch auf. 3. Vor jedem Reinigen ist das Gerät vom Stromnetz zu trennen. Vervenden Sie keine Flüssig- oderAerosolreiniger. Am besten dient ein angefeuchtetes Tuch zur...
Page 3 - Limited Warranty
Limited Warranty Hardware: D-Link warrants its hardware products to be free from defects in workmanship and materials, under normal useand service, for the following lengths of time from the date of purchase from D-Link or its AuthorizedReseller: Product Type Warranty Period Managed Switch Three Yea...
Page 5 - Trademarks; Copyright Statement
Trademarks Copyright 1997 D-Link Corporation. Contents subject to change without prior notice.D-Link is a registered trademark of D-Link Corporation/D-Link Systems,Inc. All other trademarks belong to their respective proprietors. Copyright Statement No part of this publication may be reproduced in...
Page 7 - ABLE OF
10/100 Fast Ethernet Switch User’s Guide Preface vii T ABLE OF C ONTENTS P REFACE ......................................................................... ix Purpose ..................................................................................................... ix Audience ......................
Page 9 - Purpose
10/100 Fast Ethernet Switch User’s Guide Preface ix P REFACE Congratulations on your purchase of the 10/100 Fast Ethernet Switch. Thisdevice integrates 100Mbps Fast Ethernet and 10Mbps Ethernet networkcapabilities in a highly flexible package. Purpose This manual discusses how to install and use the...
Page 10 - Manual Organization; Chapter 1 Overview; Appendix B Connector Pinouts
x Preface Manual Organization Chapter 1 Overview Describes the product, its features, packing list, and the front and rear panels. Chapter 2 Installation Provides detailed instructions on installing the 10/100 Fast Ethernet Switch.Chapter 2 includes information on table and wall-mounted installation...
Page 11 - VERVIEW; Introduction
10/100 Fast Ethernet Switch User’s Guide Overview 1 1 2 O VERVIEW Introduction The 10/100 Fast Ethernet Switch is an ideal device for linking EthernetLANs without impacting available bandwidth or for integrating 100MbpsFast Ethernet with 10Mbps Ethernet networks. The speed migration designwill bridg...
Page 12 - Product Features; Packing List
2 Overview Product Features The 10/100 Fast Ethernet Switch has the following key features: • One 3-in-1 Combo Port: UTP/STP (N-Way), BNC, and AUI. • One 10/100Mbps, N-Way UTP/STP port. • Full-duplex and half-duplex capability on both ports (applies only to thetwisted-pair connector on the combo por...
Page 13 - Front Panel; Ports; Important Note: Crossover cables must be used when
10/100 Fast Ethernet Switch User’s Guide Overview 3 • An AC Power Cord • A Wall Mount kit ( 2 tapping screws and 2 screw anchors) • Rubber Feet Front Panel The 10/100 Fast Ethernet Switch front panel includes network connectorsand LED indicators for ease-of-use. Figure 1 : 10/100 Fast Ethernet Switc...
Page 14 - Important Note: The Port 1 connectors are arranged in a
4 Overview Port 1: 3-in-1 Combo Port 1 has three different connectors – UTP/STP, BNC, and AUI. The twisted-pair connector (UTP/STP) of Port 1 is a 10/100Mbps, N-WayRJ-45 port for use with unshielded or shielded twisted-pair cabling. Becauseit is an N-Way port, the operating mode of connected station...
Page 16 - LED Indicators
6 Overview LED Indicators The 10/100 Fast Ethernet Switch has extensive LED indicators to facilitatemonitoring and troubleshooting. They include a Power LED and StatusLEDs for both ports. The Status LEDs have indicators that report on Link,Duplex, Activity, Collision and 100Mbps states. Figure 2 : L...
Page 17 - Rear Panel; Duplex Mode Switch
10/100 Fast Ethernet Switch User’s Guide Overview 7 • 100M LEDs These indicators are green when port 1 or port 2 is connected to a deviceoperating at 100Mbps. If either of these LEDs is off, then the port itcorresponds to is either not connected or is connected to a deviceoperating at 10Mbps. • FDX/...
Page 19 - NSTALLATION; Installation Site
10/100 Fast Ethernet Switch User’s Guide Installation 9 2 3 I NSTALLATION This chapter describes the installation procedure for the 10/100 Fast EthernetSwitch. The chapter includes information on installation locations,connecting power, connecting network cables, setting the port duplex mode,cascadi...
Page 20 - Installing on a Desktop or Shelf
10 Installation • Site should not exceed the electromagnetic field (RFC) standards for IEC801-3, Level 2 (3V/M) field strength. • The power outlet should be within 6 feet of the device. For a detailed list of the product’s technical specifications, refer to AppendixA, Specifications. Installing on a...
Page 21 - Installing on a Wall
10/100 Fast Ethernet Switch User’s Guide Installation 11 Installing on a Wall The product can be installed on a wall. When installing, you need to attachtwo tapping screws and two screw anchors to the bottom of the device. Wallmount supplies are included with the device. Figure 5 : Installing the 10...
Page 22 - Connecting Power; Network Connections
12 Installation Connecting Power Power is supplied to the 10/100 Fast Ethernet Switch through an AC powercord. The AC power input voltage ranges from 100 to 240 VAC. A powercable is included with the device. Figure 6 : Connecting Power Since the 10/100 Fast Ethernet Switch does not include a power s...
Page 23 - Setting the Duplex Mode
10/100 Fast Ethernet Switch User’s Guide Installation 13 10 (& 100Mbps) Mode Operations: Port 1 This port requires Category 3, 4, or 5 unshielded twisted-pair or shieldedtwisted-pair (UTP/STP) cable, a thin Ethernet coaxial cable with a T-connector, or an AUI adapter module for a thick Ethernet ...
Page 25 - Network Configuration Examples
10/100 Fast Ethernet Switch User’s Guide Installation 15 Network Configuration Examples This section provides sample configurations showing ways you might use the10/100 Fast Ethernet Switch. Figure 8 : Connecting a 100Mbps LAN Segment to a 10Mbps LAN Segment
Page 27 - PECIFICATIONS
10/100 Fast Ethernet Switch User’s Guide Specifications 17 A 4 S PECIFICATIONS This appendix lists the technical specifications for the device. Standards Compliance 10BASE-2, 10BASE-T, IEEE 802.3,100BASE-TX, IEEE 802.3u Port 1 RJ-45 N-Way, 10BASE-T or 100BASE-TX; Full or Half Duplex – 10/20Mbps or10...
Page 29 - ONNECTOR
10/100 Fast Ethernet Switch User’s Guide Connector Pinouts 19 B 5 C ONNECTOR P INOUTS This appendix describes the connector pinouts including those for: • RJ-45 connectors; • the AUI transceiver connector. RJ-45 Connectors Figure B-1 : 100BASE-TX Connector The above figure shows the arrangements of ...
Page 31 - AUI Transceiver Connector
10/100 Fast Ethernet Switch User’s Guide Connector Pinouts 21 AUI Transceiver Connector The following table gives the pinouts for the AUI connector. Table B-2 : AUI Connector Pinouts Pin Circuit Use 1 CI-S Control IN Circuit Shield 2 CI-A Control IN Circuit A 3 DO-A Data OUT Circuit A 4 DI-S Data IN...
Page 32 - Offices
Offices U.S.A. D-LINK SYSTEMS, INC. 53 Discovery Drive, Irvine, CA 92618 USA TEL: 1-714-788-0805 FAX: 1-714-753-7033 CANADA D-LINK CANADA, INC. 2180 Dunwin Drive, Unit # 6, Mississauga Ontario, L5L 5M8, Canada TEL: 1-905-828-0260 FAX: 1-905-828-5669 EUROPE (U.K.) D-LINK (EUROPE) LTD. D-Link House, 6...
Page 34 - Registration Card
Registration Card Print, type or use block letters. Your name: Mr./Ms_____________________________________________________________________________Organization: ________________________________________________ Dept. ____________________________Your title at organization: _____________________________...
