Cub Cadet 59A40003727 - Manual

Table of Contents:

• Page 2 – Table of ConTenTs; Content; finding Model nuMber; Copy the model number here:
• Page 3 – seCTion 1: safe operaTion praCTiCes; Warning; Training; Avoid injury or death. Never work under a raised loader.
• Page 4 – operaTional; avoid injury or Death from rollover accidents:
• Page 5 – MainTenanCe; Adjustment of system relief pressure should be done by a; sTorage; cause serious injury or death. Securely store loader and attach; warning! Your responsibiliTY
• Page 6 – labels found on loader
• Page 7 – Bucket; Bucket Capacity
• Page 8 – Figure 1; Not Shown - Complete Mast & Boom Assembly 1 pc
• Page 9 – seCTion 7: unpaCking THe loader; figure 2; carefully cut off the plastic wrapping.; if Using an Overhead Lift; When positioning the lifting devices, use care to; if an Overhead Lift is not available; boom and mast assembly off the shipping pallet.
• Page 10 – seCTion 8: iniTial insTallaTion; TraCTor preparaTion; the lH and RH mounts are heavy and awkward; install the rH and LH mounts as follows:; holes on the mounting plate of the assembly.; figure 3; When positioning the RH mount on the tractor,; installing the Front Mount receiver; figure 4; staggered pattern, evenly tighten all hex cap screws and lock
• Page 11 – Use care when working on the front; it may be necessary to manually roll; figure 6; cylinder to the boom arm.; Using an Overhead Lift For initial installation; the bottoms of the masts are high enough to clear the front
• Page 12 – figure 7; before leaving the operator’s seat. Proceed to “Installing the; Pre-Charging Cylinders for initial installation; the free ends of the hydraulic hoses.; figure 8; the boom cylinders. Cut and remove the ties if present.; Checking implement Control Lever Opera-; Use extreme caution when perform-; Lower Boom; Hydraulic Outlets
• Page 13 – initial installation of Loader on Tractor; if an overhead lift was used and the pistons of the two; Checking implement Control Lever Operation; If for any reason the color coded plugs of the outlets; figure 9; Hydraulic
• Page 15 – secure with the two lynch pins.; disMounTing THe loader; the bucket must be installed to remove and; seCTion 9: disMounTing and MounTing THe loader
• Page 16 – MounTing THe loader; if the loader is in storage for an extended period of time,; Pre-Charging Cylinders; ” earlier in this manual.
• Page 17 – seCTion 10: operaTion; TraCTor ballasT
• Page 18 – operaTing THe loader; To prevent possible damage to the; Lifting the Load; iMporTanT; If you should discover that your tractor; Carrying the Load; Correct
• Page 19 – avoid injury or death from; • Carry loads close to the ground to aid visibility and
• Page 20 – The float will also prevent the mixing of surface; Loading from a Bank; Surface Material
• Page 21 – For easier loading, minimize the angle of turn and; Backgrading
• Page 22 – Backfilling; Approach the pile with a flat bucket. Do not use; Handling Objects
• Page 23 – seCTion 11: MainTenanCe; lubriCaTion; • Check the level of hydraulic oil in tractor before; general MainTenanCe; ware and tighten where required.; LUBRICATION
• Page 24 – seCTion 12: TroublesHooTing; • Air in hydraulic system
• Page 25 – thread sealer on pipe threads.; Cannot lower boom; feedlots and working on concrete.
• Page 26 – seCTion 13: parTs lisT
• Page 27 – parTs lisT