Cub Cadet 500 series- User Manual

6 3. One end of each chute keeper is already attached to the chute flange. Pivot the free end of the chute keeper to align it with the chute flange and push it till it snaps into position. See Figure 4. Repeat with remaining chute keepers. Figure 4 For Models with 4 Way Chute Control Box 1. Pull the...

7 Auger Control Test 1. To check the adjustment of the auger control, push forward the left hand control until the rubber bumper is compressed. There should be slack in the cable. 2. Release the control. The cable should be straight. Make certain you can depress the auger control grip against the le...

8 1. Adjust skid shoes by loosening the four hex nuts (two on each side) and carriage bolts. Move skid shoes to desired position. 2. Make certain the entire bottom surface of skid shoe is against the ground to avoid uneven wear on the skid shoes. Retighten nuts and bolts securely. 3. Retighten the h...

9 IMPORTANT: Always release the drive control before changing speeds. Auger Control The auger control is located on the left handle. Squeeze the auger control to engage the augers. Release to stop the snow throwing action. The drive control must also be released in order to stop the auger. IMPORTANT...

10 (inside the boot) is fastened securely over the metal tip on the spark plug. • Make certain both the auger control and drive control are in the disengaged (released) position. • Move throttle control up to FAST position. Insert ignition key into slot. Make sure it snaps into place. Do not attempt...

12 • If for some reason, you have to operate the snow thrower on gravel, keep the skid shoe in the highest position for maximum clearance between ground and shave plate. • Clean the snow thrower thoroughly after each use. Chute Clean-Out Tool The chute clean-out tool is conveniently fastened to the ...

13 Figure 14 Check V-Belts Follow instructions below to check the condition of the drive belts every 50 hours of operation.1. Remove the plastic belt cover on the front of the engine by removing two self-tapping screws. 2. Visually inspect for frayed, cracked, or excessively worn out belts. Replace,...

14 Shave Plate and Skid Shoes The shave plate and skid shoes on the bottom of the snow thrower are subject to wear. Check these periodically and replace as necessary. Replacing Skid Shoe 1. Remove four carriage bolts and hex nuts which attach two skid shoes to the snow thrower on two sides. See Figu...

15 9. Re-install frame cover and flip the snow thrower back to the operating position. 10. Wrap auger belt around the engine pulley.11. Re-install belt cover with self-tapping screws removed before. Drive Belt 3. * Push idler counter-clockwise and insert a Philips head screwdriver in the hole on the...

16 . Figure 23 Figure 24 9. Reassemble new friction wheel rubber to the friction wheel assembly, tightening the four screws in rotation and with equal force. See Figure 24. IMPORTANT: Assemble the rubber on the friction wheel equally for proper functioning. 10. Insert the shift arm assembly into the...

18 SECTION 7: TROUBLESHOOTING NOTE: This section addresses minor service issues. For further details, contact an authorized service center for assistance. Problem Cause Remedy Engine fails to start. 1. Fuel tank empty, or stale fuel. 2. Blocked fuel line. 3. Choke not in ON position 4. Faulty spark ...

19 SECTION 8: THREE (3) YEAR LIMITED WARRANTY For three (3) years from the date of original purchase of our products, we will either repair or replace, at its option, free of charge, F.O.B. Factory or authorized service firm, any part found to be DEFECTIVE IN MATERIAL and WORKMANSHIP for the origina...