Crestron 277 Volt - Manual

Crestron 277 Volt

Crestron 277 Volt – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – Physical Description
  • Page 4 – Installation; Observe the following when installing the cabinet:
  • Page 5 – Wiring; MAIN LUG ONLY
  • Page 6 – MCB BREAKER DETAIL
  • Page 7 – installation. The jumper shorts the; SW; and; DM; terminals so that the load circuit is energized when the branch
  • Page 8 – Turn on the circuit breakers.; NET
  • Page 9 – NET Port Wiring
  • Page 10 – OVERRIDE Port Wiring; Override
  • Page 11 – Testing; Manual Control; Switch Function; Override Mode
  • Page 12 – Save Override Settings; button for three seconds. The; OVR; LED blinks to indicate the new override settings have been stored.; System Operation and Commissioning; must; be performed to ensure system operation.
  • Page 13 – Problem Solving; TROUBLE; Further Inquiries; to fully benefit from all
  • Page 14 – Appendix A: Setting Module Net IDs; Setup
  • Page 15 – Appendix B: Module Specifications; SPECIFICATION GLX-DIM6
  • Page 16 – Return and Warranty Policies; Merchandise Returns / Repair Service
Loading the manual

CRESTRON GREEN LIGHT™ Architectural Dimming

Introduction

CRESTRON GREEN LIGHT architectural dimming cabinets come pre-configured with GLX architectural dimming
and switching modules already installed. In addition, branch circuit breakers come preinstalled and prewired to the
modules. The cabinets only require installation and wiring of feed and load circuits.

Industry Compliance

The cabinet and modules are Listed to applicable UL Standards and requirements by Underwriters Laboratories Inc.

(E227280 (cabinet) and E103692 (modules))

Application

The following diagram shows CRESTRON GREEN LIGHT architectural dimming cabinets in a lighting application
that is controlled by an IPAC system.

CRESTRON GREEN LIGHT Architectural Dimming Cabinets in a Typical Lighting Application

Crestron Electronics, Inc.

Installation Guide – DOC. 6688A

15 Volvo Drive Rockleigh, NJ 07647

(2020963)

Tel: 888.CRESTRON

02.09

Fax: 201.767.7576

Specifications subject to

www.crestron.com

change without notice.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Physical Description

Architectural Dimming CRESTRON GREEN LIGHT™ Physical Description This section shows the exterior and interior dimensions of the CRESTRON GREEN LIGHT Architectural Dimming cabinet. External Dimensions of CRESTRON GREEN LIGHT Architectural Dimming Cabinets W1 W2 Ø7 16" (11 mm) MOUNTING HOLES H1 6 ...

Page 4 - Installation; Observe the following when installing the cabinet:

Architectural Dimming CRESTRON GREEN LIGHT™ Installation Observe the following when installing the cabinet: • The cabinet must be mounted by a licensed electrician in accordance with all national and local codes. Refer to the diagram below for specific requirements. • Allow adequate clearance in fro...

Page 5 - Wiring; MAIN LUG ONLY

CRESTRON GREEN LIGHT™ Architectural Dimming Wiring NOTE: All wiring must be installed in accordance with all local and national electrical codes. NOTE: Refer to the torque settings specified on pages 6, 7 and 8. CRESTRON GREEN LIGHT cabinets are shipped with GLX modules installed and prewired to the...

Other Crestron Models

All Crestron Other