Page 2 - Contents
Contents Note Name of all componentsAccessories Laying the machineConnection of the inlet/drain hoseConnection of the power cord OperationSafety warning MaintenanceTrouble shooting 2 Using advice 455 Control panel 9 678 1010 1213 Program Time Table 15 Name of all components Installation instructions...
Page 3 - Note
Note - 2 - 1. This product belongs to Class I appliances. Please pay attention to electricity safety when using: This machine uses a single- phase two-pole grounded power outlet, the outlet must be reliably grounded, and grounding terminal should not be connected with gas pipelines, water pipes and ...
Page 5 - Using advice
clothing during washing or spinning. 18. Do not open the door cover when the washing machine is spinning. 19. When the washing machine is working, do not put your hand into the bucket of the running washing machine, even if the speed is very slow, it is dangerous. Be especially careful not to let ch...
Page 7 - Installation instructions; Laying the machine; knob to adjust the washing machine to be stable.
Installation instructions Laying the machine Place the washing machine at least 5cm away from the wall. Alteration of adjustable foot In order to prevent vibration during wash operation, you can loosen level adjustment knob and change the height of the adjustable foot until the washing machine is st...
Page 8 - Connection of the inlet hose; Connection of the inlet/drain hose
Installation instructions Connection of the inlet hose 1. Select the appropriate type of outlet as shown in the figure. 5.Check for leak (1).Swing the water inlet hose gently to confirm if it’s suitable. (2).Turn on the water faucet and check for leak.A small amount of water might enter the machine....
Page 9 - Connection of the power cord; Connection of the drain hose (some modes have been connected)
Connection of the power cord The earthing which is indicated by yellow and green colour must be firmly connected to a special Earthing. Please call the technician to assemble. The socket should have assembled the 3A fuse. Never try to connect the earthing of the washing machine together with that of...
Page 10 - Control panel
Control panel Process Code Program Child lock Water level Start/Pause Power On/Off 01. Fuzzy Set the water level automatically according to the load of laundry. 05.Soak&Wash Soak for certain time before washing. Use this button to turn the washing machine on and off. 02. Heavy To wash the coverl...
Page 11 - Operation; When the preset operation finishes,; Safety warning
Operation When the preset operation finishes, the machine will power off automatically. Safety warning Warn Forbid Make sure the voltage in your living area corresponding to the one shown on the rating label of the appliance. And the wall socket is properly grounded. The power cord must be unplugged...
Page 13 - Maintenance; Clean the filter in the inlet valve; Body maintenance
Maintenance Clean the filter in the inlet valve Clean the filter in the inlet valve regularly in order to prevent it from clogging Take off the inlet hose and take out the valve filter. Clean the valve filter with a brush. Restall the valve filter and connect the inlet hose. - 12 - Body maintenance ...
Page 14 - Trouble shooting; Clean the lint filter
Trouble shooting Clean the lint filter Malfunction phenomenon Start the washing machine from rinse process, the washing machine does not input the water The wash process changes from spin to rinse The control button is useless to touch Spin delay The washing machine will start from the spin process ...
Page 15 - Trouble Shooting Method
Trouble Shooting Method For some troubles, the machine buzzer will ring and alarm, and the indicator will flash. Troubles Indicator Light No indicator No indicator No indicator No indicator Possible Cause Solution Breakdown The plug is badly connected to the socket or the switch is not activated.The...
Page 16 - Program Time Table
- 15 - / 7 3 / / 3 14 5 57 6 96 3 / Spin3 26 / 4 7 / / 19 / 38 40 Note: the table shows the default time of the system, which is not included the water inlet time. The drainage time is 2 minutes by default. The actual operation time will be different. Program Time Table 18 18 39 Program 1st rinse So...