Cortelco 7150 - Manual

T ELEPHONE U SAGE SET UP/INSTALLATION 1. Connect the telephone line cord. a. To connect without an answering machine. • Use the new line cord to connect the PHONE jack of your new caller ID phoneto the modular wall jack. b. To connect with an existing answering machine. • Use the existing line cord ...

WALL MOUNT INSTRUCTIONS 1. Install the Caller ID Telephone in wall mount position and route cords using the short linecord. See Step 1 in Telephone Usage for specific instructions. 2. Connect the adaptor. See Step 2 on the preceding page. 3. Push out the handset hook and reattach in opposite directi...

U NIT S ETUP FACTORY PRESETS The following table shows you the factory settings for your unit: Display Setting Language English LCD Contrast 3 Area Code No Setting After the adaptor is connected, the display will show as indicated below for setting. Ifyou have previously applied power, press the rev...

3. When [ ENTER AREA CODE ] appears, use REVIEW UP ( ) button and REVIEW DOWN ( ) button to set your local area code. REVIEW UP ( ) button - to change the digit from -. 0, 1, 2, -9 REVIEW DOWN ( ) button - to move to the next digit. When you are finished setting the local area code, press DELETE . T...

TONE BUTTON If the PULSE/TONE switch is set to the PULSE position, and you want to make a tone entry (ex. Telephone number into pager, access long distance, or tele-banking) afterpulse dialing, press the TONE button (*) on the dial keypad once, then dial the number. The number dialed out will be cha...

Note : If you also have subscribed to Call Waiting Caller ID service, please see the section on Call Waiting Display below. CALL WAITING DISPLAY In the past, if you had call-waiting service, a tone alerted you there was a new callcoming while you were on an existing call. Now our Call Waiting Caller...

C ALLER ID F EATURES MESSAGE LIGHT An indicator marked NEW CALL will light up to let you know when there are new calls received. If you have a voice mailbox service with your telephone company, another indicatormarked MESSAGE will flash to alert you to dial your telephone company to check your new m...

T ELEPHONE S ERVICE P ROBLEMS T ROUBLESHOOTING PHONE DOES NOT RING 1. HI/LOW/OFF ringer switch is set to OFF position 2. Line cord is disconnected at telephone outlet or at telephone end. 3. Phone is OFF HOOK . Make certain the hookswitch is depressed when the handset is in the cradle. 4. SPEAKERPHO...

20 MESSAGE ERROR HAPPENS FREQUENTLY Caller information was not transmitted properly. Check with your telephone company tosee if there is a problem with your phone line. Since our special design will always retain your stored call records, weencourage you to disconnect all the telephone cords and ada...

T ELEPHONE R EPAIR DO NOT ATTEMPT TO REPAIR THIS PRODUCT YOURSELF . Call Waiting Caller ID Telephones manufactured by CORTELCO must be returned to us for repair. You can return your telephone to CORTELCO for repair or replacement in accordance with our LIMITED WARRANTY. CORTELCO warrants THIS PRODUC...

I NDEX 22 A, B, C N, O, P Answering Device 4 No Data Sent 18 Area Code 7 Options Button 17 Call Waiting 13 Part Identification 9 Pause Button 12 D Placing Calls 10 Deleting Calls 16 Private Calls 18 Dial Button 16 Pulse Dialing 10 Display Contrast 7 Display Language 7 Q, R Duration Counter 10 Receiv...