Cortelco 1201 - Manual
Cortelco 1201 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – diagram 1
- Page 3 – HOLD
- Page 4 – FLASH; OPERATIONS; Volume setting
O
I
M
WNER'S
NSTRUCTION
ANUAL
MODEL 1201
Carefully read the instructions in this manual.
Follow all warnings and instructions marked on the unit.
When cleaning, unplug the telephone jack from the wall outlet. Use
a damp cloth.
use liquid or aerosol cleaners.
Do not use this equipment near water, eg: near a kitchen sink,
bathtub, washbowl, laundry rub, swimming pool or in a wet
basement.
Install in a protected location. Ensure all lines and cords are away
from foot traffic.
place objects on the line cord that may
cause damage or abrasion.
Avoid spilling any liquid on the unit. This may cause internal
shorting, fire or shock and is not covered under your warranty.
Do not overload wall outlets and extension cords as this can result
in the risk of fire or electrical shock.
Never push objects of any kind into this telephone as they can
touch dangerous voltage points or short out parts that could result
in a risk of fire or electrical shock.
Take the phone to a qualified technician when it requires repair
work or service. To reduce the risk of electrical shock, do not
disassemble the telephone. Opening or removing covers can
expose you to dangerous voltages or other risks. Incorrect re-
assembly can cause electrical shock during subsequent use.
Avoid using the telephone during an electrical storm. There can be
a slight risk of electrical shock from lightning.
use the telephone to report a gas leak, if in the vicinity of
the leak.
Unplug this telephone from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
If liquid is spilled into the unit.
If the unit is exposed to rain or water.
If the unit does not operate normally by following the
operating Instructions.
If the unit is dropped or the casing is damaged.
If the unit exhibits a distinct change in performance.
DO NOT
DO NOT
DO NOT
l
l
l
l
l
1.
To reduce the risk of fire, electrical shock, and injury, please follow
these basic safety precautions before you use this equipment.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
7
SAFETY INSTRUCTIONS
4
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
LOCATION OF CONTROLS 1 6 1 Hook Switch Message lamp AUTOMUTE HOLD Handset FLASH PAUSE STORE/SET Volume LCD display Memory(M1~M3) REDIAL RING VOL. VOL. M1 M2 M3 PAUSE FLASH STORE/SET AUTO MUTE HOLD REDIAL WALL INSTALLATION 3 Desk tabposition Wall mounttab position diagram 1 Slide the handset tab out ...
5 2 10. Hold button Pause button To place a call on hold, press and hang up the handset. To retrieve the call lift the handset or go off hook on any other phone connected to the line. HOLD 11. 12. Phone resetting 1. Lift the handset.2. Dial *#0000*#.3. Hang up the handset. Pressing this button will ...
This switch is located on the bottom of the telephone. For Tone Dialing, setthe switch to the T position. For Pulse Dialing, set the switch to the P position. This feature allows you to redial the last phone number dialed.a. Lift handset.b. Press . Ringer Volume Switch - There are 3 ringer levels ( ...
