Cornelius UC 701 - Manual

Cornelius UC 701

Cornelius UC 701 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
Page: / 30

Table of Contents:

  • Page 2 – TABLE OF CONTENTS; Page
  • Page 4 – SAFETY INFORMATION; Recognize Safety Information; CAUTION; Understand Signal Words; WARNING; safety; Follow Safety Instructions
  • Page 6 – GENERAL DESCRIPTION; TO THE USER OF THIS MANUAL; WARRANTY REFERENCE INFORMATION; Warranty Registration Date; DESIGN DATA
  • Page 7 – SPECIFICATION CHART
  • Page 8 – FIGURE 1. CLEARANCE REQUIREMENTS
  • Page 10 – INSTALLATION; PRE–INSTALLATION; Freight Damage Claim; Counter; Electrical
  • Page 11 – RIGHT SIDE INSTALL; LEFT SIDE INSTALL; FIGURE 2. SIDE BRACKET INSTALLATION
  • Page 12 – INITIAL START UP, CHECKS AND ADJUSTMENT INSTRUCTIONS; shut down. Adjustment is made by moving magnet up or down.; Water Level—; FIGURE 3. ICEMAKER FLOAT ASSEMBLY
  • Page 14 – GUIDE TO SERVICE; ICEMAKER CLEANING AND SANITIZING PROCEDURES; MAINTENANCE; Monthly
  • Page 15 – Semi–Annually; FIGURE 4. UPPER NUT AND BEARING ASSEMBLY; WATER LEVEL CONTROL; How Water Level Control Works
  • Page 16 – REFRIGERATION SYSTEM; NOTE: Thermostatic Expansion Valve No Adjustment; 0 Lbs Discharge Pressure; REFRIGERATION SYSTEM ADJUSTMENTS
  • Page 18 – CONDENSER MODULATING VALVE REMOVAL; BIN CONTROL
  • Page 20 – START RELAY; FIGURE 7. GEARMOTOR ASSEMBLY; TO REPLACE GEARMOTOR ASSEMBLY; FIGURE 8. AUGER AND EXTRUDING HEAD REMOVAL
  • Page 21 – AUGER AND EXTRUDING HEAD REMOVAL; INSTALLATION AND SHAFT SEAL REPLACEMENT; UPPER NUT AND BEARING ASSEMBLY; they should be replaced. Bearings to; To Replace Bearing
  • Page 22 – ELECTRICAL CHECKOUT; OVERLOAD CHECK; CAPACITOR CHECK
  • Page 23 – FIGURE 12. GEAR MOTOR OVERLOAD; SAFETY CONTROLS
  • Page 24 – GUIDE TO GOOD ICE; CHECK ICE MAKER
  • Page 25 – FIGURE 13. WIRING DIAGRAM
  • Page 27 – TROUBLESHOOTING; TROUBLESHOOTING COMPRESSORS
  • Page 28 – CERTIFICATE OF WARRANTY; TWO YEAR LIMITED ICE EQUIPMENT WARRANTY; IMI CORNELIUS
Loading the manual

IMPORTANT:

TO THE INSTALLER.
It is the responsibility of
the Installer to ensure that
the water supply to the
dispensing equipment is
provided with protection
against backflow by an air
gap as defined in
ANSI/ASME A112.1.2-1979;
or an approved vacuum
breaker or other such
method as proved effective
by test.

Water pipe connections
and fixtures directly
connected to a potable
water supply shall be
sized, installed, and
maintained according to
Federal, State, and Local
Codes.

Installation/Service Manual
UC 701 SERIES CONTINUOUS–FLOW
ICEMAKER

PRINTED IN U.S.A

IMI CORNELIUS INC; 2000–2003

IMI CORNELIUS INC

g

One Cornelius Place

g

Anoka, MN 55303-6234

Telephone (800) 238-3600 Facsimile (800) 535-4231

Part No. 630460150
February 2001
Revision Date: November 7, 2003
Revision A

THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or operating this equipment

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - TABLE OF CONTENTS; Page

i 630460150 TABLE OF CONTENTS Page SAFETY INFORMATION 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . RECOGNIZE SAFETY INFORMATION 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . UNDERSTAND SIGNAL WORDS 1 . . . . . . . ....

Page 4 - SAFETY INFORMATION; Recognize Safety Information; CAUTION; Understand Signal Words; WARNING; safety; Follow Safety Instructions

1 630460150 SAFETY INFORMATION Recognize Safety Information This is the safety-alert symbol. When you see thissymbol on our machine or in this manual, be alert tothe potentially of personal injury. Follow recommended precautions and safe operatingpractices. CAUTION DANGER Understand Signal Words A s...

Page 6 - GENERAL DESCRIPTION; TO THE USER OF THIS MANUAL; WARRANTY REFERENCE INFORMATION; Warranty Registration Date; DESIGN DATA

3 630460150 GENERAL DESCRIPTION TO THE USER OF THIS MANUAL This manual covers the installation and assembly of the Air–Cooled or Water–Cooled Model UC700 Icemakerwith the Model UC150 Dispenser. Refer to Table of Contents for page location of detailed information pertainingto questions that may arise...

Other Cornelius Models

All Cornelius Other