Cornelius P/N 3626 - Manual
Cornelius P/N 3626 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Step Two; Ice Bank Control
- Page 3 – Step Three
- Page 4 – Step Four; Grommet
P/N 185211007
1
8/25/94
IMI CORNELIUS INC.
One Cornelius Place
Anoka MN 55303–6234
Telephone (800) 238–3600
Facsimile (612) 422–3246
UNIVERSAL 750 ICE BANK CONTROL
KIT P/N 3626
A
B
C
D
A
C
Step One
A. Remove the product lines and white washers.
Clip all poly ties.
B. Unscrew the control box. Disconnect the cord
and agitator motor electrical leads. Lay the
control box over the side of the unit.
C. Remove the agitator motor. Unscrew the hex
nuts and screws holding the plate down. Re-
move the plate.
D. Disconnect the tubes to the valves. Raise the
basket and remove the ice bank control holder
by bending the top brackets.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
P/N 185211007 2 8/25/94 Step Two A B B Ice Bank Control P/N 33-5794-000 C Red LeadP/N 3576 Black LeadP/N 3575 P/N 3529 A. Snap the new ice bank control bulb holder (P/N 3529) onto the second and third coil fromthe top. B. Place the ice bank control bulb into the holder and secure it with two poly ti...
P/N 185211007 3 8/25/94 Step Three A Ice Bank Control relativeto agitator motorangle. S Apply the Warning Decal (A) to the plate.Place the plate in the unit with the decal onthe right hand side. S Tighten the plate to the basket with the hexnuts. Apply the three screws to each side. S Remove the agi...
P/N 185211007 4 8/25/94 Step Four S Reconnect all product tubing. Be sure the tapered white nylon washers arein place. S Route the tubing through the back hole of the panel and tie in place. S Apply the DANGER decal to the top of the control box. S Snap the grommet and the snap bushing into the hole...
