Cornelius CCM322/522 - Manual
Cornelius CCM322/522 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
ED/DF300 22” CCM322/522 Nordic Style Lid Kit Installation Instructions
© 2007, IMI Cornelius Inc.
- 1 -
Publication Number: 620204725INS
INSTALLATION INSTRUCTIONS
ED/DF300 22” CCM322/522 N
ORDIC
B
LACK
/G
RAY
S
TYLE
L
ID
K
ITS
This Nordic style kit applies to the Cornelius 22” wide CCM322/522 ice maker.
CAUTION: Disconnect electrical power to the dispenser before proceeding with the icemaker
adapter kit installation.
WARNING: The dispenser must be secured with 3/8-16 bolts (6) to the counter before installing
this Icemaker Adapter Kit. Refer to the installation manual and Figure 2 for the counter mounting
template.
NOTE: Adjust the automatic agitation timer located in the dispenser’s electrical control box to 5 seconds
on, 20 minutes off. Access to the timer is provided by removing the merchandiser/upper front panel.
1.
Remove the (2) screws from each side of the dispenser cabinet. and the plastic hopper covers (2)
that were shipped with the unit.
2.
Place the “K” style lid on the unit and use the (4) screws that were removed to fasten the lid in
place.
3.
Install the ice baffle on the lid assembly as shown in Figure 2.
IMPORTANT: The baffle prevents ice from over–filling the manual fill area during agitation/
dispensing with a full storage bin and forcing the manual fill cover off.
4.
Seal the icemaker to the top of the dispenser after determining the correct location for the ice maker
(see Figure 1).
A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker
outline so that the ice maker will set on the RTV.
B. Set the ice maker onto the lid and position it as required.
C. Wipe away the excess RTV.
5.
5. Drill .147 diameter holes into the ice maker cabinet and the dispenser lid using the icemaker
mounting brackets as templates. USE CAUTION SO AS NOT TO DRILL INTO ANY ICEMAKER
COMPONENTS (CONDENSER, TUBING, ETC.). Secure the brackets using the #10 sheetmetal
screws provided.
6.
Install the wire form bracket, supplied with the bin stat kit (item 4), through the 5/8” diameter hole in
the bottom of the ice maker. Wrap the eye of the wireform over the stud near the hole to the end of
Item
No.
Part No.
Name
Qty.
1
15210
Lid Assembly
1
2
22127
Icemaker Mounting Bracket
2
3
50904
RTV. 3Oz Tube
1
4
52946
52964
Manual Ice Fill Cover, Black
Manual Ice Fill Cover, Gray
1
5
91957
Label, “Disconnect Power Before
Cleaning”
1
6
620042919
ED300 Ice Baffle
1
7
620701601
#10 x 1/2” LG. Sheetmetal Screw
8
8
620701902
#8–32 Nylon Acorn Nut
4
9
620701901
Sealing Washer
4
10
621701903
#8 Nylon Washer
4
11
620204725INS Installation Instructions
1
13
630500109
Bin Stat
1
Release Date: October 5, 2007
www.cornelius.com
Revision: A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
