Cornelius 750 (R404A) - Manual

Cornelius 750 (R404A)

Cornelius 750 (R404A) – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
Page: / 37

Table of Contents:

  • Page 2 – TABLE OF CONTENTS
  • Page 4 – INTRODUCTION; Address all correspondence to:; A Product of IMI Cornelius Inc.
  • Page 7 – FIGURE 2. SPECIFICATIONS FOR 2400 SERIES
  • Page 8 – INSTALLATION INSTRUCTIONS; Here are a few points to consider:; F rise to; Remove the bolts holding the skid to the machine.; NOTE: All wiring must conform to national and local codes.
  • Page 9 – REMOTE CONDENSER
  • Page 10 – FIGURE 3. WATER LEVEL; Re–install gearmotor assembly and start machine.
  • Page 11 – STACKING INSTRUCTIONS FOR STACKING KIT 29757; NOTE: The two units must operate independently of each other.
  • Page 12 – TYPICAL WATER CIRCUIT; FIGURE 4. TYPICAL WATER CIRCUIT
  • Page 13 – TYPICAL REFRIGERANT CIRCUIT; FIGURE 5. TYPICAL REFRIGERANT CIRCUIT
  • Page 14 – This relay controls the compressor power only.
  • Page 19 – FIGURE 9. WIRING DIAGRAM RF–1100–MH
  • Page 23 – MAINTENANCE; Check power supply with machine running for proper voltage.; CAUTION: CONDENSER COOLING FINS ARE SHARP, USE CARE WHEN CLEANING.; tions, follow sanitizing and cleaning procedure.
  • Page 24 – SANITIZING AND CLEANING PROCEDURE; OR
  • Page 25 – CAUTION: CONDENSER COOLING FINS ARE SHARP. USE CARE WHEN CLEANING.
  • Page 26 – TROUBLESHOOTING
  • Page 30 – DESCRIPTION
  • Page 34 – FIGURE 15. ILLUSTRATED PARTS BREAKDOWN SERIES 2400
  • Page 35 – ONE CORNELIUS PLACE; CORNELIUS LIMITED COMMERCIAL WARRANTY PLAN
  • Page 36 – THIS PAGE LEFT BLANK INTENTIONALLY
Loading the manual

MODULAR FLAKED ICE MAKER

MODELS: SERIES 750 (R404a),

SERIES 1100 (R22),
SERIES 2400 (R404a)

Service Manual

PRINTED IN U.S.A

IMI CORNELIUS INC; 10/94 - 10/95

Part No. 166240009
OCTOBER 1994
Revised October, 1996

THIS DOCUMENT CONTAINS IMPORTANT INFORMATION
This Manual must be read and understood before installing or operating this equipment

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - TABLE OF CONTENTS

i 166240009 TABLE OF CONTENTS Page INTRODUCTION 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SPECIFICATIONS 750 AND 1100 SERIES 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SPECIFICATIONS 2400 SER...

Page 4 - INTRODUCTION; Address all correspondence to:; A Product of IMI Cornelius Inc.

1 166240009 INTRODUCTION We have strived to produce a quality product. The design has been kept simple thus insuring trouble–freeoperation. This manual has been prepared to assist servicemen and users with information concerning installation,construction and maintenance of the ice making equipment. ...

Page 7 - FIGURE 2. SPECIFICATIONS FOR 2400 SERIES

4 166240009 SPECIFICATIONS 2400 SERIES AIR IN NOTE: AIR IS EXHAUSTED OUTBACK AND SIDE OPPOSITECONDENSER OVERALL DIMENSIONS 23-9/16-IN. HIGH x 45-1/8-IN. WIDE x 27-5/16-IN. DEEP CONDENSER SIDE A B ”A”- ALTERNATE ICE DROP AREA FOR TOP UNIT WHEN TWO ARE STACKED. ”B”-ICE DROP AREA FOR BASIC UNIT. INDIVI...

Other Cornelius Models

All Cornelius Other