Cornelius 2849959200 - Manual
Cornelius 2849959200 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – NOTE: Only qualified Personnel should install this Kit.; melted from the evaporator coils.; INSTALLING ICE BANK CONTROL KIT
- Page 3 – RESTORING UNIT OPERATION; CONTENT WATER WHERE A LOCAL WATER PROBLEM EXIST.
- Page 5 – FIGURE 3. UNIT TOP VIEW
- Page 7 – ICE BANK CONTROL BULB; FIGURE 4. UNIT WIRING DIAGRAM
April 5, 1999
569000264
E
IMI Cornelius Inc; 1999
IMI CORNELIUS INC
g
One Cornelius Place
g
Anoka, MN 55303-6234
Telephone (800) 238-3600 Facsimile (612) 422-3246
INSTALLATION INSTRUCTIONS
WHITE RODGERS ICE BANK CONTROL KIT (P/N 569000263)
ON
UNIVERSAL C–750 PRE–MIX DISPENSERS
KIT FITS MODELS 2849949200, 2849949020, 2849959200, and 2849959020
IMPORTANT: All old parts (Ice bank Control Module and Mounting Bracket, Ice Bank Control Probe, and
the Ice Bank Control Probe Holder) must be returned to IMI Cornelius Inc, Attention: John Engstrom.
Send returned parts to the above address.
Read and understand these instructions thoroughly before installing this kit. Retain these instructions as part of
your equipment manual.
Table 1. Loose-Shipped Parts
Item
No.
Part No.
Name
Qty.
1
315794000
Ice Bank Control, White Rodgers
1
2
3528
Box, Ice Bank Control
1
3
186125000
Grommet,
1
4
313457000
Label, Hazard Shock
1
5
187188000
Screw, Machine, No. 8–32 X .250
2
6
3529
Holder, Control Bulb
1
7
180024000
O–Ring
2
8
3575
Electrical Wire, Black
1
9
3576
Electrical Wire, Red
1
10
325282000
Screw, Self Drilling, No. 8–18 Thread X .500 Long, No. 2 Point
2
11
32038900
Snap Bushing
1
12
040056000
Wire Tie
4
13
8901
Electrical Wire Terminal
1
14
330181000
Hex Nut
1
PREPARING DISPENSER FOR KIT INSTALLATION
WARNING: To avoid possible fatal electrical shock or serious injury to Installer, make sure
Dispenser is disconnected from power source before attempting to install this kit.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 569000264 NOTE: Only qualified Personnel should install this Kit. 1. Disconnect Unit product inlet lines from product tanks, then open dispensing valves to relieve systems pressures. 2. Disconnect electrical power from the Unit, open hinged top cover, then drain water tank. CAUTION: Never use an i...
3 569000264 5. Place product coils assembly back in position inside the Unit. Make sure ice bank control capillary tube is routed from ice bank control bulb up along right front side (facing front of Unit) of the Unit and on up to theice bank control as shown in Figure 3. 6. Connect product tubes, c...
5 569000264 FIGURE 3. UNIT TOP VIEW ICE BANK CONTROL ASSEMBLY (ITEMS 1 AND 2) AGITATOR MOTOR BRACKET UNIT WIRING HARNESS HAZARD SHOCK LABEL (ITEM 4) CAPILLARY TUBE SNAP BUSHING (ITEM 11) GROMMET (ITEM 3)
