Coleman 2000010648 - Manual

STITCH LINE

SIDEWALL SET UP InSTrUcTIonS

Before You Begin

• Ensure the shelter is set up correctly by carefully reviewing

and following all safety and installation instructions provided

with the shelter.

• The sidewall may be placed in any of the openings of the

Coleman Shelter.

• Shelter should be set at the highest position when used

with sidewall.

2. Stretch sidewall downward

until taut, insert hooks at
the two bottom corners of
sidewall into holes on the
lower part of frame posts.
(Fig. 3)

1. Unfold sidewall with the

“Lantern” logo facing
outside. Stretch elastic
straps and hook clips at
the two top corners of
sidewall to the metal rings
on the top of two frame
posts. (Fig.1 & 2)

3. Locate all hook & loop fasteners on edges of sidewall, then

wrap around frame & frame posts to secure. (Fig. 4 & 5)

4. Stretch webbing loops along

the bottom edge of sidewall,
then secure with stakes.
(Fig. 6)

5. Install the other sidewall following the same way as the sidewall

with “Lantern” logo. (Fig. 7)

Fig. 2

Fig. 3

Fig. 4

Fig. 6

To obtain additional Sidewall units,

see your local retailer or visit

www.coleman.com.

Completed Shelter with sidewall

4010015700 (ECN20020545-01)

The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219 U.S.A.

1-800-835-3278 • www.coleman.com

MADE IN CHINA

© 2011 The Coleman Company, Inc. All rights reserved.

Coleman

®

,

, and are registered trademarks of

The Coleman Company, Inc.

This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.

WARNING: Keep All FlAme ANd heAt souRces AWAy

FRom thIs teNt FAbRIc.

Fig. 1

Disassemble the Sidewall

1. Remove stakes along the bottom edge.
2. Detach hooks at the two bottom corners of sidewall from holes

on frame posts.

3. Detach all remaining fasteners.

To Store

1. All stakes must be placed in the storage bag to prevent damage

to the fabric items placed in the carry case.

2. Make sure all components are clean and dry before placing in

carry case.

3. Store in a clean, dry area.

Fig. 5

Install the Sidewall

Fig. 7

model 2000010648