Coleman 2000001188 - Manual

STITCH LINE

KOHNA

TM

TENT 18’ X 12’

MODEL 2000001188

Before you begin

Read all instructions before set up.
• Select a level campsite clear of rocks, branches, and other hard

or sharp objects, to install your tent.

WARNING: Keep clear of overhead power lines.

• Do not set up your tent under trees.
• For best results in windy conditions, position end of tent into

the wind.

• Enlist the help of at least one other person to assist you when

it is time to assemble the tent.

To Set Up Tent’s Living Quarters

1.

Unfold tent and spread out on a clean, level surface with the
door facing the desired direction. (Fig. 1)

2

. Assemble main tent poles by interlocking both longer, black

shock-corded, poles.

3

. Insert black main poles through sleeves, in top of the Living

Quarters area of tent, forming an “X” as shown. (Fig. 1)

4.

Insert one end of each black main pole into pins in front
corners of tent. (Fig. 2 & 2A)

5.

Go to opposite end of each pole and gradually apply pressure
to the pole forming an arch. Insert the pin into the pole end
at the tent corners. (Fig. 2 & 2A)

Parts and Components

Description

Part Number

Living Quarters, Main Poles, Black (2)

5010000384

Living Quarters, Side Poles, Thin, Gray (2)

5010000383

Screen Room Poles, Gray (2)

5010000382

Rainfly

5010000385

7.

Assemble 2 interlocking shock-corded, thin, gray side poles.

8

. Insert gray side poles through sleeves, in front and back of

the living quarters area of tent as shown. (Fig. 3)

NOTE:

Make sure the side poles are positioned on the

outside of the black main poles installed earlier.

Fig. 5

9.

Insert one end of each gray side pole into pins in side of tent

forming an “X”. (Fig. 4 & Fig. 4A)

10.

Go to opposite end of each pole and gradually apply pressure
to the pole forming an arch. Insert the pin into the pole end
at opposite side of tent forming an “X”. (Fig. 4)

11.

Attach large frame clips along edges of upper four corners
tent to connect black main poles and gray side
poles where they intersect. (Fig. 4 & 4B)

Fig. 3

To Set Up Tent’s Living Quarters

(continued)

(continued on other side)

Fig. 1

Door

Living Quarters

Screen Room

Main Tent Poles

Sleeves

Fig. 2

6.

Attach smaller frame clips along edges of
tent to black main poles.(Fig. 2B)

NOTE:

DO NOT attach the larger frame

clips located near the top of the tent living
quarters. They will be used in later assembly.

Sleeve at back of

Living Quarters

Sleeve at front

of Living

Quarters

Fig. 4

Sleeve at front of

Screen Room

To Set Up Tent’s Screen Room

1

. Assemble screen room poles by interlocking both longer,

gray, shock-corded poles.

2

. Insert gray poles through both sleeves on screen room as

shown. (Fig. 5)

Sleeve at back of

Screen Room

Gray Screen
Room Poles

2A

2B

4B

4A

Door

Thin, Gray,

Side Poles