Cobra 18 WX ST - Manual

Cobra 18 WX ST

Cobra 18 WX ST – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
Page: / 9

Table of Contents:

  • Page 2 – When installed in a boat; , the transceiver will not operate at; Ignition Noise Interference; CB Antenna
  • Page 3 – Temporary Mobile Operation; Operation; Controls and Indicators; receive
  • Page 4 – Antenna Connector; . This female connector permits; External Speaker; . The External Speaker Jack is used; Operating Procedure to Receive; Operating Procedure to Transmit; Select the desired channel.
  • Page 5 – On Reception; On Transmission; Maintenance and Adjustment; Make certain the microphone properly plugged in.; Replacement Warning
  • Page 6 – A Few Rules That Should Be Obeyed; You can't use CB to promote illegal activities.; Use Channel 9 For Emergency Messages Only; Permitted
  • Page 7 – NOTES
  • Page 8 – If you wish, you can order directly from Cobra; Cobra Accessories Dept.; Amount
  • Page 9 – est Cortland Street
Loading the manual

Installation

Location

Plan the location of the transceiver and microphone bracket
before starting the installation. Select a location that is conve-
nient for operation and does not interfere with the driver or
passengers in the vehicle. In automobiles, the transceiver is
usually mounted to the underneath of the dash panel, with the
microphone bracket beside it.

Mounting and Connections

The transceiver is held in the universal mounting bracket by
two thumb screws, permitting adjustment at the most conve-
nient angle.
A universal mounting bracket is supplied along with self tap-
ping screws and star washers. The mounting must be mechan-
ically strong and also provide a good electrical connection to
the chassis of the vehicle. To mount the transceiver:

1.

Determine the most con-
venient location in your
vehicle. Hold the COBRA
radio with mounting
bracket in the exact loca-
tion desired. If nothing
will interfere with mount-
ing it in the desired posi-
tion, remove the mounting
bracket and use it as a tem-
plate to mark the location
for the mounting screws.

2.

Drill necessary holes and secure mounting bracket in
location.

Operating Instructions for Your

CITIZENS BAND

2-WAY MOBILE RADIO

1

WITH INSTANT EMERGENCY CHANNEL 9

Welcome to the Cobra Family of 2-way communications.
Cobra has dedicated over 30 years of research and develop-
ment to the technology that made Cobra #1 in CB Radios.
Please take some time to read this booklet. Although this CB
is simple to operate, we want you to be aware of all the
unique features your new CB Radio offers.

THE CB STORY

The Citizens Band lies between the shortwave broadcast and
10-meter Amateur radio bands, and was established by law
in 1949. The Class D two-way communications service was
opened in 1959. (CB also includes a Class A citizens band
and Class A remote control frequencies.)
FCC regulations permit only "transmissions" (one-party to
another) rather than" broadcast" (to a wide audience). Thus,
advertising is not allowed on CB channels because that is
"broadcasting".

“Cuts Static coming in, adds Punch going out!”

Cobra proudly introduces the first Patent Pending technolo-
gy that dramatically improves the transmission and recep-
tion of CB radio signals.
This revolutionary system reconfigures the transmission sig-
nal which allows it to be transferred more effectively through
cluttered airwaves. It literally ÒpunchesÓ your message
through the hundreds of thousands of signals that are in the
air. At the same time,

SoundTracker

system dynamically

adjusts the relationship between the signal and static com-
monly referred to as noise. This allows CobraÕs

SoundTracker

system to significantly reduce the amount of static on all
incoming CB signals. The system can be further optimized
when two SoundTracker CBÕs are used to talk to each other.
The end result is a clearer, cleaner sounding reception of sig-
nals and more powerful transmission which

dramatically

improve CB Communications

WARNING

Replacement or substitution of transistors, regular diodes or
other parts of a unique nature, with parts other than those
recommended by Cobra, may cause violation of the techni-
cal regulations of Part 95 of the FCC Rules, or violation of
Type Acceptance requirements of Part 2 of the Rules.

LICENSING

Citizens Band (CB) Radio operators are no longer re-
quired to obtain an FCC license to operate their CB
equipment or provide station identification.
Nevertheless, an operator of a CB radio station is still re-
quired to comply with the communications act and with
the rules of CB Radio Operation.

Model

18.WX.ST.MAN.ORIG. 9/19/97 2:54 PM Page 1

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - When installed in a boat; , the transceiver will not operate at; Ignition Noise Interference; CB Antenna

Mobile whip antennas utilize the metal body of the vehicle asa ground plane. When mounted at a corner of the vehicle theyare slightly directional, in the direction of the body of the vehi-cle. For all practical purposes, however, the radiation pattern isnon-directional. The slight directional charac...

Page 3 - Temporary Mobile Operation; Operation; Controls and Indicators; receive

Temporary Mobile Operation To operate your COBRA transceiver from a car on a tempo-rary basis, you may want to purchase an additional ciga-rette lighter adapter from your COBRA dealer. This adapterand a magnetic mount antenna allow you to quickly"install" your transceiver for temporary use. ...

Page 4 - Antenna Connector; . This female connector permits; External Speaker; . The External Speaker Jack is used; Operating Procedure to Receive; Operating Procedure to Transmit; Select the desired channel.

B. Rear Panel 1. Antenna Connector . This female connector permits connection of the transmission line cable male connec-tor to the transceiver. 2. External Speaker . The External Speaker Jack is used for remote receiver monitoring. The external speakershould have 8-ohm impedance and be rated to han...

Other Cobra Models

All Cobra Other