Clifford CYBER 2 - Manual - manualsarea.com

Page 3 - Low battery warning; Auto matic re mote con trol low- battery warn ing; Re mote con trol bat tery re place ment

Wel come to the world of high- technology ve hi cle se cu rity and con ven ience C ongratulations on the purchase of your Clifford Electronics mobile security/convenience system. Clifford Electronics has long been recognized as the leading manufacturer of high-technology vehicle security systems. Ou...

Page 4 - User- Selectable AutoArmingTM; AutoArming entry delay:; False Alarm Pre ven tion & FACTTM; Op tional Wire less Im mo bi lizerTM; How to in ter pret the LED status in di ca tor; Off; Auto mat ic Battery- Saving Mode

Add ing new re mote con trols For other drivers, or to control Clifford G4 systems on your other cars with the same remote, you can buy additional remote controls from any Clifford Dealer (or direct from the Customer Service Department of your nearest Clifford Headquarters listed on the front cover)...

Page 5 - “hidden”; The system’s factory- set valet code is 2:; Entering a code; immediately; case, the system will revert to the previous code.; Re mote Con trolled Valet Mode

User- Selectable AutoLock and Aut oUn Lock™ Some vehicles are incompatible with the AutoLock and AutoUnLock features. For your safety and that of your passengers, the doors automatically lock the instant you turn on the ignition. When you turn the ignition off, AutoUnLock automatically unlocks the d...

Page 6 - Glass Tampering Sensor:; Choose when your Per son al ized Si ren Sounds play:; Smart Au toTest ingTM; Specific malfunction identification:; LED flashes; Auto matic mal func tion by pass with AutoRe Moni tor ingTM

Smart trunk re lease op tion If you have this option, you may use the button to remotely release the trunk latch. The system’s electronic interlock prevents unintentional activation of the remote trunk release when you drive, or when the system is armed. The Smart Trunk Release feature requires inst...

Page 7 - How to change a user- selectable fea ture:; button of the dash- or console-mounted PlainView 2; Step- by- step pro gram ming in struc tions; Pause; NOTE

Smart prior in tru sion at tempt alert If you hear three chirps when you disarm, it means that a trigger or sensor was activated in your absence. When you turn on the ignition, the LED will flash 1-8 times, pause, then repeat the flash cycle 4 more times. Count the flashes in one cycle and refer to ...

Page 8 - Ta ble of User- Selectable Fea tures; Feature Select; controlled valet mode and turn off the FACT anti-falsing feature:; Enter program mode

a. To select another feature in that same column, repeat step 5 within the next 5 seconds (after 5 seconds, 3 chirps mean you are back to the “Feature Select” position). b . To select a different feature column, go to step 4. c. To exit program mode, turn the ignition off (you’ll hear 3 chirps and t...

Page 9 - BOLD; type on the

Re set All Fea tures If you wish to reset all the user-selectable features to their normal factory presets, you can do so simply by choosing the Reset all features selection (column 1, row 7) on the Table of User-Selectable Features . If you do so, all features — except the programmed remote control...

Clifford CYBER 2 - Manual

Table of Contents:

Summary

Other Clifford Models