Clifford 2.2X - Manual

5 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . fcc/id notice This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including int...

6 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . 2 2--w wa ayy rre em mo otte e c co on nttrro oll ffu un nc cttiio on nss The 2-way remote control buttons are used to send commands to the system. The descriptions below reflect the standard config- uration for this system. The buttons can...

7 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . and Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by pressing these buttons simultaneously. The auxiliary output controls __________________________. rre em mo otte e o o...

8 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . Alarm Page If the alarm system is triggered while armed, an Alarm Page will be sent to the remote control. When the remote receives an Alarm Page, the LED icons will display the alarm system status information and the remote control will ge...

9 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . out of range notification If a command is issued from the remote, but the remote is beyond the range of the vehicle to receive the command, the remote responds with 2 sets of 3 quick beeps and the Green LED will flash 6-times. p prro og grr...

10 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . Page notification The remote control can be programmed to notify the user of a page (audibly beeping if the vehicle’s status changes, e.g. door unlocked, engine started, vehicle violation, etc.). Press to select page On/Off. One beep is pa...

11 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . second chirp after arming and note that the in-vehicle’s status LED is flashing in groups, see the Diagnostics Section of this guide. This extra chirp is called Bypass Notification. The remote responds to active arming with one beep and th...

12 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . The remote responds to passive arming with one beep and the Orange LED will flash 3-times to indicate successful arming of the system. When armed your vehicle is protected as follows: ➤ Light impacts trigger the Warn Away ® signal. When tr...

13 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . multi-level security arming Multi-Level Security Arming allows you to select which of the system's inputs or sensors will be active and which will be bypassed when the system is armed. (See Table of Zones section of this guide.) Pressing (...

14 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . After each press of the to reach the next level of security, the remote will emit normal arm notification (1 beep and 3 flashes of the Orange LED). For easiest operation in reaching each level of security, press immediately aafftteerr each...

15 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . The remote will indicate disarm notification with 2 beeps and 3 flashes of the Orange LED. If disarming after the system has been triggered, the remote control will send a diagnostic notifi- cation as a reminder. These diagnostic notificat...

16 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . disarming without a 2-way remote This feature allows you to disarm the security system without the 2- way remote should it be lost, damaged, or disabled. In order to dis- arm the system without a 2-way remote, you must have the vehicle’s i...

17 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . The remote will indicate disarm notification with 2 beeps and 3 flashes of the Orange LED. silent mode To temporarily turn off the arm or disarm chirps, use Silent Mode™. Simply press for less than one second before arming or disarming, an...

18 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . panic mode If you are threatened in or near your vehicle, you can attract attention by triggering the system with your 2-way remote. Just press for two seconds, and you will enter Panic Mode. The siren will sound and the parking lights wil...

19 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . To enter or exit Valet ® Mode using the 2-way remote: 1. Open any vehicle door. 2. Press . 3. Press . 4. Press again. The in-vehicle status LED will light solidly if you are entering Valet ® Mode, and it will go out if you are exiting Vale...

20 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . NPC ® is programmable. See Programming Options section of this guide. a au uxxiilliia arryy o ou uttp pu uttss ((o op pttiio on nss)) This system also supplies outputs that can control convenience options such as remote control trunk relea...

21 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . This occurs at the remote after the system has received the com- mand to activate any of the Auxiliary outputs. d diia ag gn no ossttiic css This iTcrivoprivocessorrs at thheliar-17.tny oyiv S s y s t e S t a t u s C h i r p ( s ) T j 1 1 ...

22 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . disarming diagnostics Extra disarm chirps are the Tamper Alert. If four chirps are heard when disarming, the system was triggered in your absence. If five chirps are heard, a zone was triggered so many times that Nuisance Prevention ® Circ...

23 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . table of zones The zone number is the number of in-vehicle LED flashes usedby the system to identify that input. The standard input assign-ments are listed below, along with spaces to write in any optionalsensors or switches you have had i...

25 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . o ow wn ne err rre ec co og gn niittiio on n Owner Recognition is a feature available exclusively from Directed. Using the Directed Bitwriter, a hand-held program- ming tool, your dealer can program many of the system settings. The program...

27 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . ➤ A Accttiivvee aarrm miin ngg (only with the 2-way remote) or passive arming (automatic arming 30-seconds after the last door hasbeen closed). ➤ Arming/disarming confirmation siren chirps oon n or off. ➤ The ignition controlled door lock ...

28 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . ajar when leaving the vehicle. Forced passive arming ensures that the security system will be armed in every situation. ➤ Automatic Engine Disable (AED) on or ooffff: The purpose of this feature is to protect the vehicle from being stolen ...

29 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . security system with the Directed Bitwriter, the full triggered response can be programmed for any duration ranging from 1 to 180 seconds. ➤ Nuisance Prevention ® Circuitry oon n or off: Please refer to the NPC ® section of this manual for...

31 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . Directed has engineered this vehicle security system, the Failsafe ® Starter Kill, and the VRS ® feature to provide the best combina- tion of personal safety and property protection available. When properly installed, the system can never ...

32 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . if someone takes your keys and 2-way remote by force in a parking lot. vrs ® triggered sequence Fifteen seconds after the last door has closed, the in-vehicle LED will begin flashing. This delay is intended to allow you time to distance yo...

33 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . disarming the vrs ® Take the time to familiarize yourself with the VRS ® triggering se- quence and the disarm procedure. It is important to recognize and identify the VRS ® trigger sequence and know how to disarm it in case of accidental a...

34 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . g gllo ossssa arryy o off tte errm mss 2-Way Remote : Hand-held, 2-way transceiver which operates the various functions of your system. Control Unit: The "brain" of your system. Usually hidden under the dash area of the vehicle. It...

35 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . Trigger or Triggered Sequence: This is what happens when the alarm "goes off " or "trips". The triggered response of your system consists of the siren sounding and parking light flashing for the programmed duration. Valet ®...

36 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . sse ec cu urriittyy & & c co on nvve en niie en nc ce e e exxp pa an nssiio on nss Here we have listed only some of the many expansion options available. Please contact your dealer for a complete explanation of all the options avai...

37 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . power activated, then Directed's 522T trunk release solenoid can often be added. Power Window Control: Automatic power window control is pro- vided with the 529T and 530T systems. Mobile Video: This system is compatible with Directed Video...

39 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c . QUICK REFERENCE GUIDE To arm using your 2-way remote ➤ You can activate, or arm, the system by pressing on your remote for one second. When the system arms, you will hear a short siren sound, or chirp, andthe parking lights will flash once...

Directed Electronics, Inc. Vista, CA 92081 www.directed.com © 2004 Directed Electronics, Inc. - All rights reserved G919437 05-04 The company behind this system is Directed Electronics, Inc. Since its inception, Directed has had one purpose, to provide consumers with thefinest vehicle security and c...