Page 2 - might have with your installing dealer.
C ongratulations on your purchase of this Ungo System. Pleaseread this manual thoroughly to familiarize yourself with yoursystem’s components and operation. Discuss any questions you might have with your installing dealer. Record the serial number of your Ungo system and keep all dealerrecords and r...
Page 3 - Table of Contents
Table of Contents 1. About Your Ungo Security System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 1 2. Remote Transmitters Remote Transmitter Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2Optional Dri...
Page 5 - Each Ungo MS2000 System comes with:; Main Unit; Options and Convenience Features; About Your Ungo Security System
Ungo Security Systems are state-of-the-art vehicle protection systems equipped with featuresdesigned to: p Deter potential intrusions to the vehicle by continually flashing the system LED status indicator while the system is Armed, giving a visual indication to any passer-by that thevehicle is equip...
Page 6 - Remote Transmitter Layout; Optional Driver Door Priority Feature*; Button 1
Page 2 - MS2000 Owner’s Manual Remote Transmitter Layout The Ungo MS2000 comes with 2 multi-function Remote Transmitters used to control nearly all ofthe system’s features. Each time a transmitter button is pressed, the LED will flash to indicate that a transmission istaking place. Button 1 Arms the...
Page 7 - Deleting Transmitters (Adding a Remote Transmitter; and; Erasing All
MS2000 Owner’s Manual - Page 3 Battery Replacement Your Ungo Remote Transmitter uses a 12 volt alkaline battery, which will need to be replacedfrom time to time. Under normal conditions, the battery may last for up to a year before it needsreplacement. When your Remote Transmitter’s battery is in ne...
Page 8 - Remote Arming; Armed; Remote Sensor Bypass; Basic Features
Page 4 - MS2000 Owner’s Manual Remote Arming When Armed, the system monitors and protects 3 independent areas, or zones , including the doors, hood/trunk, and shock sensor. To Arm the System: 1. Turn off the ignition.2. Press Button 1. • The siren/horn will chirp once.*• The doors will lock.• The pa...
Page 9 - Remote Disarming; Tamper Alert; Adding a New; Arming Mode Selection
MS2000 Owner’s Manual - Page 5 To Bypass the sensors: 1. After arming the system, press Button 1 again on the Remote Transmitter within 5 seconds. • The siren will chirp 5 times, indicating the sensors have been bypassed. 2. The sensors will remain bypassed until the next time the system is armed. R...
Page 10 - Arming Mode; Panic Mode
Page 6 - MS2000 Owner’s Manual To set the Arming Mode: 1. Turn the ignition on.2. Within 4 seconds, press Button 3 to change the setting. one chirp = Passive Arming with chirp two chirps = Active Arming three chirps = Passive without chirp 3. Turn the ignition off to save your selection. Passive Arm...
Page 11 - Emergency Override; Automatic System Rearming; Full Time System Diagnostics
MS2000 Owner’s Manual - Page 7 Emergency Override In case your Remote Transmitter becomes inoperable, or it is lost or stolen, you can still enterand drive your car by using the following procedure. Be sure that you have your ignition keysready and that you know the location of the Override switch b...
Page 12 - Valet Mode; Ignition Controlled Door Locking; Ignition Controlled Door Unlocking*; Other Features
Page 8 - MS2000 Owner’s Manual Valet Mode Allows you to temporarily disable the security system when the car is being service or turned over to aparking attendant. To turn Valet Mode on or off: 1. Turn on the ignition.2. Press and hold the override switch.3. While holding the override switch, turn o...
Page 13 - Trunk Disarm; Status Indications
MS2000 Owner’s Manual - Page 9 To operate the Auxiliary Function with the system Disarmed , press Button 3 for three seconds. • This function will stay active for as long as Button 3 is held. Trunk Disarm If the Auxiliary Function is being used to remotely open your car’s trunk, your installer can p...
Page 14 - Technical Data; Specifications; Warranty Information
Page 10 - MS2000 Owner’s Manual Technical Data Specifications Main Unit Voltage: 12v, negative ground Current Consumption: <15mA Temperature Range: -40oF to +257oF Auxiliary Output Capability: 500mA Internal Relays: (1) 30A, (1) 15A Transmitter Current Consumption: <.00mA, standby Battery Type...
Page 16 - Ungo Security Corporation
Ungo Security Corporation A Clarion Company 661 West Redondo Beach Blvd. Gardena, CA 90247 800-Go-Clarion www.clarion-usa.com © Ungo Security Corporation, Gardena, CA 97-MS2000-10 Rev. 1 (11/00)