Clarion APX400.2M - Manual

Clarion APX400.2M

Clarion APX400.2M – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 2 – save your original sales receipt as proof of; TABLE OF CONTENTS
  • Page 4 – Gain Control; - This allows you to set the nominal operating level of the; Bass Boost Control; - The crossover frequency is fully; Crossover Frequency Multiplier Switch; - This switch is equipped with a 12dB per octave; Input Mode Switch; - This switch allows you to set the input mode. Stereo; Speaker Level Inputs; - These provide connections for a high-level stereo
  • Page 5 – CONNECTIONS FOR POWER AND SPEAKERS
  • Page 6 – APPLICATIONS; Bridged- Mono Subwoofer System; Figure 3; Set X-Over Mode to LP and adjust
  • Page 7 – Figure 4; - In this application, the amplifier is used in stereo and drives two
  • Page 8 – Mixed-Mode Satellite and Subwoofer System; The amplifier can be configured for a mixed-mode operation. The
  • Page 10 – If wires must cross, run them perpendicular to each other.
  • Page 11 – Electrical connections for the APX400.2M.
  • Page 15 – NOTES
Loading the manual

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - save your original sales receipt as proof of; TABLE OF CONTENTS

INTRODUCTION The Clarion APX400.2M is a full-featured two-channel amplifier incorporatingthe following features: • Full frequency response with low distrotion and exceptional signal to noise performance • Advanced circuit design that features bridgeable and mixed mode operation for use in various sy...

Page 4 - Gain Control; - This allows you to set the nominal operating level of the; Bass Boost Control; - The crossover frequency is fully; Crossover Frequency Multiplier Switch; - This switch is equipped with a 12dB per octave; Input Mode Switch; - This switch allows you to set the input mode. Stereo; Speaker Level Inputs; - These provide connections for a high-level stereo

• Gain Control - This allows you to set the nominal operating level of the amplifier. The amplifier ’s range, 250mV to 2.5V for RCA inputs or 500mV to5V for speaker level inputs, can accommodate input levels from virtually anybrand of source unit. • Bass Boost Control - The amplifier also features a...

Page 5 - CONNECTIONS FOR POWER AND SPEAKERS

CONNECTIONS FOR POWER AND SPEAKERS The rear panel of the APX400.2M contains power and speaker connections asshown below. 3 1. Left Speaker Output2. Right Speaker Output3. Remote Turn-on Input 4. Ground Input5. Battery + 12V Input6. 25 Amp Fuse Figure 2-

Other Clarion Models

All Clarion Other