Cisco 1700 - Manual
Cisco 1700 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Command; exit; reload
- Page 3 – ROM Monitor Commands
- Page 4 – Command Descriptions; reset or i
- Page 5 – Disaster Recovery with TFTP Download; TFTP Download Command Variables
- Page 6 – Required Variables; Variable
- Page 7 – Using the TFTP Download Command; Enter the tftpdnld command as follows:
- Page 8 – Configuration Register
- Page 10 – Console Download; Command Description; Argument
- Page 11 – Error Reporting
- Page 12 – Debug Commands; stack or k—Produce a stack trace. For example:
- Page 13 – frame—Display an individual stack frame.
B-1
Cisco 1700 Series Router Software Configuration Guide
78-5407-03
A P P E N D I X
B
ROM Monitor
This appendix describes the Cisco router ROM monitor (also called the bootstrap
program). The ROM monitor firmware runs when the router is powered up or
reset. The firmware helps to initialize the processor hardware and boot the
operating system software. You can perform certain configuration tasks, such as
recovering a lost password or downloading software over the console port, by
using the ROM monitor. If there is no Cisco IOS software image loaded on the
router, the ROM monitor runs the router.
This appendix contains the following sections:
•
•
•
•
Disaster Recovery with TFTP Download
•
•
Entering the ROM Monitor
To use the ROM monitor, you must be using a terminal or PC that is connected to
the router by means of the console port. Refer to the installation chapter in the
Hardware Installation Guide for your router, for information about connecting the
router to a PC or terminal.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Appendix B ROM Monitor Entering the ROM Monitor B-2 Cisco 1700 Series Router Software Configuration Guide 78-5407-03 Follow these steps to configure the router to boot up in ROM monitor mode thenext time it is rebooted. Timesaver A break (system interrupt) is always enabled for 60 seconds after the ...
B-3 Cisco 1700 Series Router Software Configuration Guide 78-5407-03 Appendix B ROM Monitor ROM Monitor Commands ROM Monitor Commands Enter ? or help at the ROM monitor prompt to display a list of availablecommands and options, as follows: rommon 1 > ? alias set and display aliases command boot b...
Appendix B ROM Monitor Command Descriptions B-4 Cisco 1700 Series Router Software Configuration Guide 78-5407-03 Command Descriptions Table B-1 describes commonly used ROM monitor commands. Table B-1 Common ROM Monitor Commands Command Description help or ? Displays a summary of all available ROM mo...
