Char-Broil 463270309 - Manual

WARNING If “growing” bubbles appear do not use or move the LP cylinder. Contact an LP gas supplier or your fire department! Connecting Regulator to the LP Cylinder 1. LP cylinder must be properly secured onto grill. (Refer to assembly section.) 2. Turn all control knobs to the OFF position. 3. Turn ...

6. Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP cylinder valve, resulting in some resistance. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools. NOTE...

WARNING For Safe Use of Your Grill and to Avoid Serious Injury:• Do not let children operate or play near grill. • Keep grill area clear and free from materials that burn. • Do not block holes in sides or back of grill. • Check burner flames regularly. • Use grill only in well-ventilated space. NEVE...

Burner Flame Check •Remove cooking grates and troughs. Light burners, rotate knobs from HI to LOW . You should see a smaller flame in the LOW position than seen on HI . Perform burner flame check on sideburner, also. Always check flame prior to each use. If only low flame is seen refer to "Sudde...

CAUTION Storing Your Grill •Clean cooking grates.•Store in dry location.•When LP cylinder is connected to grill, store outdoors in a well- ventilated space and out of reach of children. •Cover grill if stored outdoors. Choose from a variety of grill covers offered by manufacturer. •Store grill indoo...

First Time Use Read your Assembly Manual and ensure the grill is put together properly. Remove all Point-of-Purchase advertising material from all grill surfaces before first use. We recommend operating your grill on its highest setting for 15-20 minutes prior to your first use. This aids in removin...

Outdoor grilling is really quite simple. You'll succeed with burgers, dogs, or steaks usually on your very first try. With experience, you will learn how to work with your grill, creating more imaginative meals all the time. This knowledge makes up the art of grilling. Before you start grilling, org...

USDA Recommended Safe Minimum Internal Temperatures Beef, Veal, Lamb, Steaks, & Roasts 145° F Fish 145° F Pork 160° F Beef, Veal, Lamb Ground 160° F Egg Dishes 160° F Turkey, Chicken & Duck Whole,Pieces & Ground 165° F Cooking on your new grill is a hands-on experience, and it is recomme...

Why Clean? We've all heard the saying 'An ounce of prevention is worth a pound of cure'. This is great advice when it comes to keeping your grill clean. Routine Care Periodic cleaning of this grill is necessary,as grill fires can occur when grease andfood debris collect in the bottom of the grill. A...

This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated...

PARTS LIST NOTE: Some grill parts shown in the assembly steps may differ slightly in appearance from those on your particular grill model. However, the method of assembly remains the same. 15 NOT Pictured: Key Qty Description A 1 BOTTOM SHELF B 1 TANK SCREW, F/ BOTTOM SHELF C 2 CASTER, LOCKING D 2 C...

2 1/4-20x1/2” screw 1 Attach side panels to bottom shelf using three 1/4-20x1/2” screws, 7mm lock washers, and 7mm flat washers per panel. IMPORTANT: Panel with large hole must Be on left side of bottom shelf. 7mm lock washer 7mm flat washer Attach the two locking casters at the rear of the bottom s...

3 4 This step requires two people to lift and position grill head onto cart. Carefully lower the grill head onto the cart, aligning slots at bottom of grill head with posts on cart side panels. Make sure the regulator hose is hanging outside the cart. Grill head must face open side of cart. Place lo...

On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in lower holes, using one 1/4-20x1½” screw, 7mm lock washer, and 7mm flat washer on each side. Do not fully tighten screws until side shelf installation is complete in later steps. 5 19 ...

11 Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½” screws, 7mm lock washers, and 7mm flat washers on each side. NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD PO...

13 Insert hinge pin on bottom of doors into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release hinge pin into door. Left door Hinge pin on bottom of door Top of door PRESS Right door 23 12 Inside of cart, insert rear shield tab into left slot on ...

15 24 Install flame tamers by sliding one end of each flame tamer into slots at front of firebox and resting opposite end on pins in back of firebox. Back of firebox Front of firebox Flame tamer Note: Some parts omitted for clarity of illustration Flame tamers 14 Connect each of the wires from the m...

. 17 25 LP CYLINDER IS SOLD SEPARATELY. Fill and leak check the cylinder before attaching to grill and regulator (see Use & Care section). Once cylinder has been filled and leak checked, place cylinder into hole in bottom shelf. Make sure cylinder valve is facing front of grill. Secure cylinder ...

Unscrew on cart right side panel. Insert AA battery into ignitor, negative (—) end first. Replace the cap. electronic ignition cap – 19 26 AA Battery Electronic Ignition Cap + - On back of grill, slide grease tray into opening in upper back panel. CAUTION Failure to install grease tray will cause ho...

EMERGENCIES: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Troubleshooting Emergencies Problem Gas leaking from cracked/cut/burned hose. Gas leaking from LP cylinder. Gas leaking from LP cylinder valve. Gas leaking between LP cylinder and regulator c...

Troubleshooting ( continued ) Problem Burner(s) will not light using ignitor. Burner(s) will notmatch light. Sudden drop in gasflow or low flame. Flames blow out. Flare-up. Persistent grease fire. Flashback...(fire in burner tube(s)). Unable to fill LP tank. One burner does not light from other burn...

Troubleshooting - Integrated Electronic Ignition Problem (Ignition) SECTION I No sparks appear at any electrodes when burner control knobs are turned to ; no noise can be heard from spark module. SECTION II No sparks appear at any electrodes when burner control knobs are turned to ; noise can be hea...