Chamberlain MR650 - Manual - manualsarea.com

Page 2 - The Protector System; must be used for all; WARNING; START BY READING THESE IMPORTANT SAFETY INSTRUCTIONS

1 CONTENTS PAGE SAFETY INSTRUCTIONS . . . . . . . .1CARTON INVENTORY . . . . . . . . . .2TOOLS REQUIRED . . . . . . . . . . . .2DOOR REQUIREMENTS . . . . . . . .2PREPARE & TEST THE DOOR . .3-4INSTALLATION . . . . . . . . . . . . . .5-6CONNECT ELECTRIC POWER . . .6ADJUSTMENT . . . . . . . . . . ....

Page 3 - Warning label and risk of entrapment label; CARTON INVENTORY; on the door; DOOR REQUIREMENTS

1. Instruction manual (this document)2. Stop collar3. Clamp bracket4. Release handle, cord and risk of entrapment card5. Transmitters (2)6. Wireless wall button7. Hardware bag8. Weight bar9. Clamp plate 10. Warning label and risk of entrapment label CARTON INVENTORY 1 TOOLS REQUIRED 2 1. Ladder2. Ad...

Page 4 - TESTING THE DOOR; Non opener side; INSTALLING THE STOP COLLAR; Is the stop collar

TESTING THE DOOR 4 Complete the following test to ensure your door is wellbalanced, and not sticking or binding: • Disable all locks and remove any ropes connected to the garage door. • Lift the door to about halfway and then release it. The door should remain spring balanced. • Raise and lower the ...

Page 5 - PINNING THE DOOR; Free curtain; THE RELEASE HANDLE & CORD; click; OPERATING THE MANUAL RELEASE

PINNING THE DOOR Note: A ballooning door may delay the safety reversalresponse and can compromise garage door security. • To remedy any ballooning place self tapping metal screws or rivets where the curtain leaves the roll. Secure thesethrough the curtain into the drum wheel at each end of theroll. ...

Page 6 - Optional accessory not provided; • Align the extension pole holes with the drive legs.; LEFT / RIGHT HAND INSTALLATION

5 Release cable Rope Manual ReleaseWarning Label Release handle Overhand knot Optional accessory not provided • Align the extension pole holes with the drive legs. • Insert the extension poles into the drive leg and fix in place using screws provided. • Slide the reinforcing brace over the poles and...

Page 7 - INSTALLATION PROCEDURE

6 INSTALLATION PROCEDURE NOTE: The opener can be installed on either sideof the door. The following instructions are forRIGHT HAND INSTALLATIONS (as illustrated i.e.inside the garage looking out). For left handinstallations, reverse the instruction terminology(eg LEFT for RIGHT etc). Preparation: • ...

Page 8 - SETTING THE LIMITS & RIGHT OR LEFT OPERATION; Setting right or left hand operation:

7 SETTING THE LIMITS & RIGHT OR LEFT OPERATION Travel limits set how far your door goes up and down. Your opener must be configured correctly for right or lefthand installation to operate correctly, if not the door will rotate in the reverse direction. NOTE: The MR850/MR650 opener is factory con...

Page 9 - • Press the LRN button twice to place the opener into; LRN; Press twice; Note: Courtesy LEDs will go out after 2.5 minutes; FIXING WARNING LABELS; Repeat test of the safety reverse system.; TESTING THE SAFETY REVERSE SYSTEM; The safety reverse system test is important.; SETTING THE FORCE; STANDARD INSTALLATION COMPLETE

8 The force, as measured on the closing edge of the door,should not exceed 400N (40kgf). If the closing force ismeasured to more than 400N, the Protector System TM (IR Beams) must be installed (refer section 17). • Press the LRN button twice to place the opener into force adjustment mode. The indica...

Page 10 - when it is installed and; MUST be installed; IR Beams must be installed; INSTALL THE PROTECTOR SYSTEMTM (IR BEAMS) OPTIONAL ACCESSORY

9 NOTE: This accessory must be used for allinstallations where the closing force as measuredon the bottom of the door is over 400N (40kgf). After the opener has been installed and adjusted, theProtector System™ accessory can be installed.Instructions are included with this accessory. The Protector S...

Page 11 - LRN Press LRN; or; TO ADD Transmitters / Wireless wall button; LRN Press LRN for 9 seconds; TO DELETE ALL REMOTES; Deleting ALL transmitter codes

WIRELESS PROGRAMING (OPTIONAL ACCESSORIES) NOTE: Transmitter(s) and wall button supplied with your opener are factory programmed. INSTALLING YOUR CM128 WIRELESS WALL BUTTON To install: • Carefully pry open the CM128 and locate the two screws for mounting. • Attach to the wall using the two screws an...

Page 12 - Wireless fingerprint access system C379; Using the “LRN” Button:

11 professional Wireless fingerprint access system C379 Full instructions are available with this accessory.Once you have enrolled your user into the C379 youcan program the unit into your opener. Using the “LRN” Button: 1. Press and release the LRN button on the opener, the orange LED will light. 2...

Page 14 - SPARE PARTS

13 If the supply cord is damaged, it must bereplaced by the manufacturer, its serviceagent or similarly qualified personsin order to avoid hazard. 001A6621 041A6811 041A6813 001A6528 041A6815 (MR850)041A7282 (MR650) 041A6814 (MR850)041A7292 (MR650) 001B6681 041A6778 (MR850) 041A6778-1 (MR650) 041D66...

Page 15 - ACCESSORIES

14 1 2 3 4 5 8 9 10 11 12 13 LOCK LIGHT 6 14 7 ENROLL FAIL RETRY SEND PASS READY ENROLL ACCESSORIES 1. Model CM128 2 Channel wireless wall button 2. Model CM844 4 Channel transmitter 3. Model C940 1 Channel transmitter 4. Model C943 3 Channel transmitter 5. Model C945 3 Channel mini transmitter 6. M...

Page 16 - DIAGNOSTIC CHART; light glows steadily, attach the receiving eye.; System Failure

15 DIAGNOSTIC CHART Symptom: One or both of the indicator lights on the IR Beams are not onsteadily.• Inspect sensor wires for an electrical short (eg. staple in wire), correct wiring polarity (black/white wires reversed), broken or disconnected wires, replace/attachas needed. • Disconnect all wires...

Page 17 - TROUBLESHOOTING

TROUBLESHOOTING 1. The opener will not operate from either the ACTIVATION button or the transmitters : • Does the opener have electric power? Plug a lamp into the outlet. If it does not work, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. ...

Page 18 - OPERATION OF YOUR OPENER; Obstruction behaviour:; MAINTENANCE OF YOUR OPENER; be installed on all garage door openers.; CARE OF YOUR OPENER

OPERATION OF YOUR OPENER Your opener can be activated by any of the followingdevices: • The ACTIVATION button Press the button until door starts to move. • The wall control, outside keyswitch or keyless entry system (if you have installed any of theseaccessories). • The Transmitter or Wireless Wall ...

Chamberlain MR650 - Manual

Table of Contents:

Summary

Other Chamberlain Models