Chamberlain HE60R - Manual - manualsarea.com

Page 3 - Start by Reading These Important Safety Instructions

The Protector System must be used forall installations where the closing forceas measured on the bottom of the door isover 400N (40kgf). Excessive force will interfere with the proper operation of theSafety Reverse System or damage thegarage door. After installation, ensure that the parts ofthe door...

Page 4 - Tools Required; and socket wrench; Carton Inventory

Tools Required 2 1. Ladder (or similar device to safely support door weight)2. Adjustable wrench for U-bolts already installed on the door3. 8mm socket, 10mm socket and 13mm extended socket and socket wrench 4. 30mm socket extension (for minimum sideroom installations) 5. Drill and 5.5mm drill bit6....

Page 6 - Non motorised side

Testing the door Disable all locks and remove any ropes connected tothe garage door. Complete the following test to ensure your door is wellbalanced, and not sticking or binding: • Lift the door to about halfway and then release it. The door should remain suspended entirely by its spring. • Raise an...

Page 7 - Preparing the Opener; left hand side; Place the Opener in Manual Release mode.; • Pull the release cord down and across to; right hand side; Attaching the Extension Poles (if required)

5 Preparing the Opener 7 For left hand side installations the wire jumper should be removed . Place the Opener in Manual Release mode. • Pull the release cord down and across to engage the ball into the cup. The drive forks should now be able to bemoved manually. NOTE: To re-engage the opener, pull ...

Page 8 - Installation steps; installed; Ensure that the U-bolt on the left hand side of the door is; You will need assistance for the following steps

6 Installation steps 8 FOR RIGHT HAND INSTALLATIONS(REFER SECTION 7, page 5) • Ensure that the opener position jumper (wire connector) is installed (refer Section 7, page 5). • Place the opener in manual release mode (refer Section 7, page5). • Open the roller door fully. For safety, tie a rope arou...

Page 9 - Pinning the Door; Attach the Release Handle and Cord; To disengage the opener

Pinning the Door 11 Use two metal self tapping metal screws provided tohold the curtain to the door drum. Note: A ballooning may delay the safety response andcan compromise your garage door security. • Pull the release cord down Firmly to disengage the motor. Once the door is closed pull the cord do...

Page 10 - Setting the Limits

Setting the Limits The Travel Limits regulate the points at which thedoor will stop when moving UP or DOWN. During theSetUp procedure, the motor will run and operate thedoor. The Opener must be fully installed on the doorand all installation steps completed beforeproceeding. Make sure the door is cl...

Page 13 - • Multi function Control Panel; Motorlift/ HomEntry Compatible

CARE OF YOUR OPENER When properly installed, your opener will provide high performance with minimal maintenance. The opener doesnot require additional lubrication. Limit and Force Settings: These settings must be checked and properly set whenthe opener is installed. Weather conditions may cause some...

Page 14 - Troubleshooting

12 Troubleshooting 1. The opener doesn't operate from either the GREEN start button or the remote controls: • Does the opener have electric power? Plug a lamp into the outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on pag...

Page 15 - OPERATION OF YOUR OPENER; The green start button; MAINTENANCE OF YOUR OPENER

13 OPERATION OF YOUR OPENER Your opener can be activated by any of the followingdevices: • The green start button Hold the button down until door starts to move. • The Wall Control, Outside Keylock or Keyless Entry System (if you have installed any of these accessories). • The Remote Control Transmi...

Chamberlain HE60R - Manual

Table of Contents:

Summary

Other Chamberlain Models