Chamberlain 5580A-2GB - Manual

Chamberlain 5580A-2GB

Chamberlain 5580A-2GB – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
Page: / 14

Table of Contents:

  • Page 2 – Before You Begin; Contents; Page; Start by reading These Import Safety Instructions
  • Page 3 – ASSEMBLY SECTION; If your opener came with a one piece rail, proceed to step 8.
  • Page 4 – On; each; side of opener measure the distance from the opener to the; Do not bend at the bracket holes.; If it is necessary to cut rope, heat seal cut end with a match or; Attach Rail to Header Bracket; To enable the rail to clear sectional door springs, it may be; INSTALLATION SECTION; Position the Header Bracket
  • Page 5 – For one-piece doors, do not connect door arm to trolley
  • Page 6 – Program your Opener & Remote; Using the “LEARN” Button
  • Page 7 – Repeated operation of the opener during adjustment; Test the Safety Reverse System
  • Page 8 – strongly recommended for homeowners with young
  • Page 9 – Force Settings; The garage door opens and closes by itself:
  • Page 11 – Chamberlain strongly recommends that the; SPECIFICATIONS
  • Page 12 – D e c l a r a t i o n o f C o n f o r m i t y; GARAGE DOOR OPENER WARRANTY; All rights reserved
  • Page 13 – TM ̄‹Ì·Ù·
  • Page 14 – AB; AB
Loading the manual

Instructions – Garage Door Operator Model 5580A-2GB

INT

Int. Service(+49) 6838/907 172

www.iftmaster.de

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Before You Begin; Contents; Page; Start by reading These Import Safety Instructions

1-en 1 Before You Begin 1. Look at the wall or ceiling above the garage door. The header bracket must be securely fastened to structural supports. 2. Do you have a finished ceiling in your garage? If so, a support bracket and additional fastening hardware (not supplied) may be required. 3. Depending...

Page 3 - ASSEMBLY SECTION; If your opener came with a one piece rail, proceed to step 8.

2-en Completed Installation As you proceed with the assembly, installation and adjustmentprocedures in this manual, you may find it helpful to refer back tothis illustration of a completed installation. (1) Header Sleeve (2) Chain Pulley Bracket (3) Trolley (4) Rail (5) Chain (6) Hanging Bracket (7)...

Page 4 - On; each; side of opener measure the distance from the opener to the; Do not bend at the bracket holes.; If it is necessary to cut rope, heat seal cut end with a match or; Attach Rail to Header Bracket; To enable the rail to clear sectional door springs, it may be; INSTALLATION SECTION; Position the Header Bracket

3-en 3 Position the Opener NOTE: A 25mm (1") board (1) is convenient for setting an ideal door- to-rail distance (unless headroom is not sufficient). Raise the opener onto a stepladder. Open garage door. Place a25mm (1") board (1) laid flat on the top section of door near thecenterline as sh...

Other Chamberlain Models