CDA WC370 - Manual - manualsarea.com

Page 2 - Important

Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse of the appliance. This appli...

Page 3 - Recommendations; Before First Use

• The plastic housing on the water inlet pipe contains an electrically operated valve. The wires that connect to this valve are inside the inlet hose. Do not cut through the inlet hose, and do not put the plastic housing in water. • Children could get locked inside the appliance. Therefore when disp...

Page 4 - Control Panel

Control Panel Power button (1) • To switch the dishwasher on or off, press the power button (1). When you switch on the dishwasher, the end of programme light will illuminate, and two dashes will appear on the display. Programme display (2) The programme display shows the selected programme and the ...

Page 6 - Detergent; Salt

Detergent To fill the detergent compartment 1. Push the latch to open the compartment.2. Add the required amount of detergent. The main detergent compartment “b” (figure 1) has lines to allow for specific amounts of detergent. These are marked at either 15 cm 3 or 25 cm 3 , to be used depending on h...

Page 8 - Softener Adjustment; Softener adjustment; Testing strip; Hardness level is adjusted to level 3 as a factory setting.; ENGLISH

Softener Adjustment The efficiency of your dishwasher depends on the softness of the tap water. To ensure best efficiency, the dishwasher is equipped with a system that reduces the hardness in the mains water supply. The efficiency will increase when the system is correctly set. To find out the wate...

Page 9 - Rinse Aid; Rinse Aid; Rinse Aid; Rinse Aid Adjustment

Rinse Aid To fill the rinse aid compartment 1. Open the rinse aid compartment by turning and removing the cap as shown in figure 4. 2. Fill the rinse aid compartment until the rinse aid indicator goes dark, as shown in figure 5 (where a indicates the compartment is empty, and “b” indicates the compa...

Page 12 - Programme Listing

Programme Listing Programme name and temperature Auto Intensive 60-70 O Auto- normal 50-60 O Auto- delicate 30-50 O Intensive 60 O Express 60 O Economy 50 O Quick 40 O Prewash - Intensive+ 70 O Level of soil High High Low High Medium Medium Low - High Detergent required A+B A+B A A+B A+B A+B A - A+B...

Page 13 - Care and Maintenance; Cleaning the seals in the machine door,; Cleaning the seals in the machine door,; MAINTENANCE AND CLEANING; Cleaning the seals in the machine door,

Care and Maintenance Before beginning any care or maintenance, you should always disconnect the appliance from the electricity supply, and also turn off the water supply. Door seals Wipe the dishwasher door seals regularly with a damp cloth to remove any residues. Filters You should clean the filter...

Page 14 - Failure Codes and Troubleshooting

Failure Codes and Troubleshooting The programme indicators also serve as a diagnostic display to help in the event of a problem with the appliance. 13 Error Code Error description Advice F1 Alarm is active against water overflow. Turn off the dishwasher and disconnect the water supply. Contact CDA s...

Page 16 - Electrical information

Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 ...

Page 17 - Installation

Installation • Do not install this appliance if it is damaged in any way. Installing a damaged appliance may invalidate the warranty. • The water supply tap should be located in an adjacent cupboard so that it can be accessed after installation. • Ensure the appliance is level by adjusting the feet ...

Page 18 - Fitting the integrated appliance door

Fitting the integrated appliance door Where non-standard integrated appliance doors are supplied, additional fitting instructions are required to ensure compatibility with this product. The machine is supplied with a fitting template and these instructions should be followed as normal. However, the ...

Page 19 - Notes

Page 20 - Passionate about style; To contact our Customer Care Department, or for Service,

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu Passionate about style To contact our Customer Care Department, or for Service, please contact us on the details below.

CDA WC370 - Manual

Table of Contents:

Summary

Other CDA Models