Carrier TSTATBBREC01- User Manual

Carrier TSTATBBREC01

Carrier TSTATBBREC01– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
Page: / 13

Table of Contents:

  • Page 2 – Table Of Contents; TROUBLESHOOTING; CAUTION; Follow; WARNING
  • Page 3 – Set; Fan Auto; Set; Fan Auto; Set; Fan Auto
  • Page 4 – REMOVE OLD THERMOSTAT
  • Page 5 – MOUNT WALL PLATE AND WIRE; refer to the chart below,
  • Page 6 – Connections & Switches - Setting House Code; Circuit Board; HP; ON
  • Page 7 – Antenna; Heat Pump; ON Indicator
  • Page 8 – Sample Wiring Diagrams; Receiver; Wire, 1 Stage Cooling, 1 Stage Gas Heat; If using electric heat this option must be
  • Page 11 – special needs; Sample Wiring Diagram
  • Page 12 – at the furnace; Note: 2 resistors may be used at the same time.; For Problem Heat
  • Page 13 – INSTALLATION NOTES
Loading the manual

MULTI-STAGE WIRELESS RECIEVER

Installation Instructions

TSTATCCREC01
TSTATBBREC01
P474-1100REC

Wireless Reciever

NOTE: Read the entire instruction manual before starting the installation.

Form: IM-TSTAT-10

Cancels:

Printed in U.S.A.

Catalog No. 13TS-TA36

HEAT

COOL

FAN

POWER

HEAT

PUMP

HEAT

COOL

&

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Table Of Contents; TROUBLESHOOTING; CAUTION; Follow; WARNING

Page 1 Table Of Contents PREPARATION REMOVE OLD THERMOSTAT MOUNT WALL PLATE & WIRECONNECTIONS & SWITCHES WIRING DIAGRAMSCALABRATION TROUBLESHOOTING CAUTION Follow Installation Instructions carefully. DISCONNECT POWER TO THE HEATER - AIR CONDITIONER BEFORE REMOVINGTHE OLD THERMOSTAT AND INSTA...

Page 3 - Set; Fan Auto; Set; Fan Auto; Set; Fan Auto

Proper installation of the receiver will beaccomplished by following these stepby step instructions. If you are unsureabout any of these steps, call a qualifiedtechnician for assistance. Assemble tools as shown below. Flat BladeScrewdriver Wire cutter& Stripper Drill with3/16 inchDrill Bit Make ...

Page 4 - REMOVE OLD THERMOSTAT

Turn off the power to the Heating/AirConditioning system at the main fusepanel. Most residential systems have a separate breaker for disconnectingpower to the furnace. Remove the cover of the old thermostat.If it does not come off easily check forscrews. Loosen the screws holding the thermostatbase ...

Other Carrier Models