Carrier FE4ANF002000 - Installation Manual

FE4A

FE5A

Installation Instructions

COMMUNICATING FAN COIL

FOR PURON

r

REFRIGERANT

SIZES 002, 003, 004, 005, 006

NOTE

: Read the entire instruction manual before starting the

installation.

PAGE

SAFETY CONSIDERATIONS

1

. . . . . . . . . . . . . . . . . . . . . . . . .

INTRODUCTION

1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

INSTALLATION

1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Check Equipment

1

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Mount Fan Coil

2

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Air Ducts

6

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Electrical Connections

7

. . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Refrigerant Tubing Connection & Evacuation

8

. . . . . . . . . .

Condensate Drain

9

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Unit Start- Up

10

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Accessory Installation

10

. . . . . . . . . . . . . . . . . . . . . . . . . . . .

Start- Up and Troubleshooting

11

. . . . . . . . . . . . . . . . . . . . .

FE4A, FE5A Fan Coil Sequence of Operation

14

. . . . . . . . .

CARE AND MAINTENANCE

14

. . . . . . . . . . . . . . . . . . . . . . . .

PURON

R

REFRIGERANT QUICK REFERENCE GUIDE

16

.

SAFETY CONSIDERATIONS

ELECTRICAL OPERATION HAZARD

Failure to follow this warning could result in personal injury

or death.
Consult a qualified installer, service agency, or your

distributor or branch for information or assistance. The

qualified installer or agency must use factory- authorized kits

or accessories when modifying this product. Refer to the

individual instructions packaged with kits or accessories

when installing.

!

WARNING

Follow all safety codes. Wear safety glasses and work gloves. Use

quenching cloth for brazing operations. Have fire extinguisher

available. Read these instructions thoroughly and follow all
warnings or cautions attached to the unit. Consult local building

codes and National Electrical Code (NEC) for special
requirements.
Recognize safety information. This is the safety- alert symbol

.

When you see this symbol on the unit and in instructions manuals,
be alert to the potential for personal injury.

Understand the signal words DANGER, WARNING, CAUTION,
and NOTE. These words are used with the safety- alert symbol.

DANGER identifies the most serious hazards which

will

result in

severe personal injury or death. WARNING signifies hazards

which

could

result in personal injury or death. CAUTION is used

to identify unsafe practices which

may

result in minor personal

injury or product and property damage. NOTE is used to highlight

suggestions which

will

result in enhanced installation, reliability, or

operation.

ELECTRICAL OPERATION HAZARD

Failure to follow this warning could result in personal injury

or death.
Before installing or servicing unit, always turn off all power

to unit. There may be more than 1 disconnect switch. Turn

off accessory heater power if applicable.

!

WARNING

INTRODUCTION

Model FE4A, FE5A fan coils are designed to be installed with a
communicating User Interface. The FE4A, FE5A fan coils will

provide airflow at a rate commanded by the User Interface. The
nominal airflow/ton rate is 350 CFM/ton. The User Interface will

modify the commanded airflow under certain operating modes.

Refer to the User Interface literature for further system control
details. This fan coil will not respond to commands from a

common thermostat except under certain emergency situations
explained in this document. The instructions contained herein

provide guidance to successfully install this fan coil.
Model FE5A fan coil units are designed for upflow or downflow

applications only. Model FE4A fan coil units are designed for

flexibility and can be used for upflow, horizontal, or downflow
applications. These units are designed specifically for Puron

r

(R- 410A) refrigerant and must be used only with Puron

r

refrigerant air conditioners and heat pumps as shipped.
These units are designed to meet cabinet air leakage of less than

2% at 0.5 inches W.C. and cabinet air leakage less than 1.4% at 0.5
inches W.C. when tested in accordance with ASHRAE 193

standard. Because of this, units need special attention in the
condensate pan and drain connection area and when brazing

tubing.
These units are available for application in systems of 18,000
through

60,000

Btuh

nominal

cooling

capacities.

Factory- authorized, field- installed electric heater packages are
available in 5 through 30 kW. See Product Data for available

accessory kits.