Carrier 50PEC09-18- User Manual
Carrier 50PEC09-18– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Table 1 — 50PEC Physical Data; BASE UNIT 50PEC
- Page 3 – EPT —; IPT —; WATER IN; SS; CONDEN; WATE; Right Hand Configuration; oNAL; or; Left Hand Configuration
- Page 4 – Fig. 2 — 50PEC18 Piping Dimensions; OUT; BLOWER DECK; OPTIONAL; VINYL HO; WATER; IPT OR
- Page 6 – Fig. 4 — 50PEC18 Bottom Return Cabinet Dimensions — Right Hand Piping
- Page 8 – Fig. 6 — 50PEC18 Bottom Return Cabinet Dimensions — Left Hand Piping
- Page 10 – Fig. 8 — 50PEC18 Front Return Cabinet Dimensions — Right Hand Piping
- Page 11 – Fig. 9 — 50PEC09-15 Front Return Cabinet Dimensions — Left Hand Piping
- Page 12 – Fig. 10 — 50PEC18 Front Return Cabinet Dimensions — Left Hand Piping
- Page 19 – Fig. 18 — 50PEC Unit with Complete C and LON Controllers
- Page 20 – Fig. 19 — 50PEC Unit with Deluxe D and LON Controllers
- Page 25 – Table 2 — Electrical Data — 50PEC Units; Step 5 — Wire Low Voltage Connections; only; Fig. 25 — Typical Aquazone Control Board; Fig. 26 — Typical Aquazone Accessory Wiring; THERMO
- Page 26 – Table 3 — Recommended Thermostat Wire Sizes; Step 6 — Install Supply and Return Piping; WIRE SIZE; Fig. 28 — Taco SBV Valve Wiring; CAUTION
- Page 27 – Fig. 29 — Temporary Connection for Flushing System Piping
- Page 28 – Table 4 — Air and Water Limits; Table 5 — Water Quality Guidelines
- Page 31 – Table 9 — Coaxial Water Pressure Drop; UNIT
- Page 32 – per 30 M of Pipe; Table 11 — Antifreeze Percentages by Volume; Cooling Tower/Boiler Systems —
- Page 33 – Table 13 — Complete C Control LED Code and Fault Descriptions
- Page 35 – Fig. 30 — Gravity Flow Method
- Page 36 – Fig. 32 — Thermistor Nominal Resistance; Fig. 33 — FP1 and FP2 Thermistor Location; COAX —
- Page 37 – Table 15 — Troubleshooting
- Page 40 – HEATING CYCLE ANALYSIS; = SUCTION TEMPERATURE – SATURATED SUCTION TEMPERATURE; SUBCOOLING; = SATURATED CONDENSING TEMPERATURE – LIQUID LINE TEMPERATURE
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Catalog No. 04-53500075-01
Printed in U.S.A.
Form 50PEC-C1SI
Pg 1
9-10
Replaces: New
Installation, Start-Up and Service Instructions
CONTENTS
Page
SAFETY CONSIDERATIONS
. . . . . . . . . . . . . . . . . . .1,2
GENERAL
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-26
Step 1 — Check Jobsite
. . . . . . . . . . . . . . . . . . . . . . . . 2
Step 2 — Check Unit
. . . . . . . . . . . . . . . . . . . . . . . . . . 17
• STORAGE
• UNIT PROTECTION
Step 3 — Mount Unit
. . . . . . . . . . . . . . . . . . . . . . . . . . 17
Step 4 — Wire Electrical Connections
. . . . . . . . . . 17
• SUPPLY VOLTAGE
• EXTERNAL LOOP POWER CONNECTION
• 220-V OPERATION
Step 5 — Wire Low Voltage Connections
. . . . . . . 25
• WATER FREEZE PROTECTION
• ACCESSORY CONNECTIONS
• WATER SOLENOID VALVES
• OPTIONAL WALL-MOUNTED THERMOSTAT
• OPTIONAL PREMIERLINK™ CONTROLLER
Step 6 — Install Supply and Return Piping
. . . . . . 26
• SUPPLY AND RETURN HOSES
• SUPPLY AND RETURN PIPING
Step 7 — Install Condensate Piping
. . . . . . . . . . . . 26
PRE-START-UP
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 27-29
System Cleaning and Flushing
. . . . . . . . . . . . . . . . 27
System Checkout
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
FIELD SELECTABLE INPUTS
. . . . . . . . . . . . . . . .29,30
Complete C Control Jumper Settings
. . . . . . . . . . . 29
Complete C Control DIP Switches
. . . . . . . . . . . . . . 29
Deluxe D Control Jumper Settings
. . . . . . . . . . . . . 29
Deluxe D Control DIP Switches
. . . . . . . . . . . . . . . . 29
Deluxe D Control Accessory
Relay Configurations
. . . . . . . . . . . . . . . . . . . . . . . 30
START-UP
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30-32
Operating Limits
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
Unit Start-Up
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Flow Regulation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Antifreeze
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
Cooling Tower/Boiler Systems
. . . . . . . . . . . . . . . . . 32
Ground Coupled, Closed Loop and Plateframe
Heat Exchanger Well Systems
. . . . . . . . . . . . . . . 32
OPERATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .32,33
Power Up Mode
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32
Units with Aquazone Complete C Control
. . . . . . . 32
Units with Aquazone Deluxe D Control
. . . . . . . . . 32
COMPLETE C AND DELUXE D BOARD
SYSTEM TEST
. . . . . . . . . . . . . . . . . . . . . . . . . . . .33,34
Test Mode
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
Retry Mode
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
Aquazone Deluxe D Control LED Indicators
. . . . . 33
SERVICE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34-36
Unit Inspection
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
System Flushing
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
Water Coil
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
Page
Refrigerant System
. . . . . . . . . . . . . . . . . . . . . . . . . . . 34
Condenser Cleaning
. . . . . . . . . . . . . . . . . . . . . . . . . . 34
Condensate Pans
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
Blower Motors
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
Compressor
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35
Safety Control Reset
. . . . . . . . . . . . . . . . . . . . . . . . . . 35
Checking System Charge
. . . . . . . . . . . . . . . . . . . . . 36
Refrigerant Charging
. . . . . . . . . . . . . . . . . . . . . . . . . 36
Air Coil Fan Motor Removal
. . . . . . . . . . . . . . . . . . . 36
TROUBLESHOOTING
. . . . . . . . . . . . . . . . . . . . . . .36-38
Thermistor
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
Control Sensors
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36
START-UP CHECKLIST
. . . . . . . . . . . . . . . . . CL-1, CL-2
SAFETY CONSIDERATIONS
Installation and servicing of air-conditioning equipment can
be hazardous due to system pressure and electrical components.
Only trained and qualified service personnel should install,
repair, or service air-conditioning equipment.
Untrained personnel can perform basic maintenance func-
tions of cleaning coils and filters and replacing filters. All other
operations should be performed by trained service personnel.
When working on air-conditioning equipment, observe precau-
tions in the literature, tags and labels attached to the unit, and
other safety precautions that may apply.
Improper installation, adjustment, alteration, service, mainte-
nance, or use can cause explosion, fire, electrical shock or other
conditions which may cause personal injury or property
damage. Consult a qualified installer, service agency, or your
distributor or branch for information or assistance. The qualified
installer or agency must use factory-authorized kits or accesso-
ries when modifying this product. Refer to the individual
instructions packaged with the kits or accessories when
installing.
Follow all safety codes. Wear safety glasses and work
gloves. Use quenching cloth for brazing operations. Have fire
extinguisher available. Read these instructions thoroughly and
follow all warnings or cautions attached to the unit. Consult
local building codes and applicable electrical codes for special
installation requirements.
Understand the signal words — DANGER, WARNING, and
CAUTION. DANGER identifies the most serious hazards
which will result in severe personal injury or death. WARNING
signifies hazards that could result in personal injury or death.
CAUTION is used to identify unsafe practices, which would re-
sult in minor personal injury or product and property damage.
IMPORTANT: Read the entire instruction manual before
starting installation.
AQUAZONE™
50PEC09-18
Water Source Heat Pump Console Unit with
PURON
®
Refrigerant (R-410A)
50 Hz
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Carrier 50PEC09-18
Summary
2 GENERAL The 50PEC water source heat pump console unit is a decen- tralized room terminal designed for field connection to a closed-circuit piping loop. Units are typically installed in perimeter zones, usually un- der windows. Supply air is discharged directly into the condi- tioned space through ...
3 LEGEND *Dimension reduced by fitting if selected.NOTE: Dimensions shown are in inches. Dimensions in parentheses are in millimeters. EPT — External Pipe Thread IPT — Internal Pipe Thread Fig. 1 — 50PEC09-15 Piping Dimensions WATER IN WATER OUT COMPRE SS OR ACCE SS PANEL CONTROL BOX 1. 8 4 (77) CON...
4 LEGEND *Dimension reduced by fitting if selected.NOTE: Dimensions shown are in inches. Dimensions in parentheses are in millimeters. EPT — External Pipe Thread IPT — Internal Pipe Thread Fig. 2 — 50PEC18 Piping Dimensions Right Hand Configuration OPTMOTWAT OPTAUTVAL V WATE R . 8 75 ( OD C 3 /4"...