Carrier 33CSHUMID-01- User Manual
Carrier 33CSHUMID-01– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Dehumidify using only the air conditioner; Overview
- Page 3 – Installation; Humidity Module; Humidity Jumper; HUM; OR
- Page 4 – Humidity Operation; For more information
- Page 5 – Dehumidifying With The DEHUM Terminal*; To control a MISC output for
- Page 6 – Dehumidifying With Air Conditioning*; If Cool to Dehumidify is on
- Page 7 – Reheat with Cool to Dehumidify*; This feature allows the thermostat to turn
- Page 8 – Label Selection and Placement
- Page 9 – Warranty
P/N
P/N 33CSHUMID-01
33CSHUMID-01
OWNER’S
MANUAL
OWNER’S
MANUAL
Humidity
Module
Humidity
Module
When installed, the
thermostat may have*
the ability to:
Control a compatible
humidifier
Display relative humidity
level as measured at the
thermostat
Dehumidify (Cool to
dehumidify, reheat, control a
dehum. terminal equipped
furnace board.
2
2
4
4
6
6
8
8
X
X
ZZ
1
1
5
5
7
7
9
9
YY
3
3
1
3
3
Carrier Corporation - 08/06 - Patents Pending
Complete Control from
Compatible with thermostat models:
33CS450-01, 33CS420-01 &
33CS400-01
for a complete list contact Carrier
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
View the ambient humidity at the thermostat location Control a humidifier with the HUM terminal on the thermostat Dehumidify using only the air conditioner Dehumidify with Reheat using your HVAC’s second stage electric strip heater Dehumidify using the DEHUM terminal on your furnace’s circuit board ...
Installation Page 2 Thermostat circuit board. Humidity Moduleplug located on the thermostat circuit board. Humidity Module Humidity Jumper Set this jumper for HUM. HUM NO HUM OR HP GAS B ELEC GAS (F A N ) W1 Y1 G R C MISC2 CK1 CKGND O W2 MISC1 RS2 RSGND MISC3 RS+5 Rs1 W3 PROG HUM DEHUM MISC3 MISC2 M...
Humidity Operation Page 3 To control a MISC output for humidification, place the MISC1, MISC2, or MISC3 jumper on the term- inal labeled HUM. This will supply 24VAC to the selected MISC terminal on the backplate of the thermostat when the humidity in the home falls below the setpoint you have chosen...
