Califone International R-2000 - Manual
Califone International R-2000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – GENERAL; SYSTEM COMBINATION
- Page 3 – OPERATION INSTRUCTIONS OF OVERALL SYSTEM
- Page 4 – USED AS A STAND ALONE SYSTEM; INSTALLATION OF THE RECEIVER; as shown in; CONNECT; as; USED AS A PACK MOUNT SYSTEM
CAUTION
1.Since use of an antenna extremely influences efficiency of the wireless microphone
system, proper selection and set-up are necessary. The shorter the better is the
most important rule to keep distance between the microphone and the receiiving
antenna.
2 In case of multi-channel operation, proper selection of non-interference channels is
of utmost importance.
3 Remove batteries out of the microphone if the unit is not to be used for a long period.
4 Tuned circuits and variable resistors & capacitors inside the transmitter and the
receiver have been precisely adjusted, please do not make any adjustment.
Otherwise, normal operation will be interrupted.
Printed in Taiwan, SEP 2001
R-1000/R-2000
WIRELESS MICROPHONE SYSTEM
Operating Manual
R
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
R-1000 / R-2000 is a VHF high-band non-diversity system with quartz controlledfixedfrequency design. The receiver must be combined with Califone's Q- and M-series of wireless microphone. 1. MATCHING WIRELESS MICROPHONE:Q- and M- series such as Q-1000 & M-1000 1. MAIN FRAME:R-1000 / R-20002. ACCE...
1.POWER SWITCH AND VOLUME CONTROL Turn the knob clockwise until it clicks to switch on the power. Further turning will increase the volume. 2.POWER ON INDICATOR When power is switched on the power on LED will light up. 3.RF SIGNAL INDICATOR Indicates RF signal received. As soon as signal is emitted ...
USED AS A STAND ALONE SYSTEM INSTALLATION OF THE RECEIVER 1.Connect the AF output of the receiver from unbalanced output jack to input jack of the mixer by an output cable attached with "PHONE" plug as shown in Fig. 2. 1.Install an antenna perpendicularly to the antenna input jack at the rea...
