Buffalo Technology WMR-G54 - Manual

Page 3 - Front Panel

Table of Contents Introduction 3 A Look at the Hardware 3 Front Panel 4 Back Panel 4 Hardware Installation 5 Configure the Router for the first time 5 Configuring IP Settings on Your Computer 5 Configuring with Web Browser 6 Device Info 7 Quick Setup 8 Configure WAN (DSL) Connectivity 8 Configure Wi...

Page 4 - Back Panel; Connector Description

following table defines the behavior for each LED: LED Represents Activity / Status Power Power The Power LED will light up when the device is powered on. USB USB Connection - Steady on – USB is connected to a host PC. - Blinking – Data is being transferred over the USB connection. 1, 2, 3, 4 LAN Co...

Page 5 - Configuring IP Settings on Your Computer

cable to the USB port and connect the other end to the computer. Reset Use an object, such as a stretched paper clip, to press the button for at least 3 seconds. LAN 1, 2, 3, 4 LED will light up for a short time and then be off. You can release the button now to reset the device to its factory-defau...

Page 6 - For Windows 2000/Windows XP; Configuring with Web Browser; Before you begin

For Windows 2000/Windows XP 1. Right-click on My Network Places icon on the desktop and then click Properties in menu. 2. Double-click Local Area Connection icon and then click Properties button. 3. Scroll down to highlight TCP/IP (your network card) and then click Properties button. 4. Check the ra...

Page 9 - Connection Type; Encapsulation Mode

UBR With PCR, CBR, Non Realtime VBR, and Realtime VBR. 4. A Connection Type page will appear. There are several ways for the device to have a public IP address and then to access the Internet. You have to check with your ISP about which way is adopted. Check the radio button of your connection type....

Page 16 - Save

2. Check the box Enable Bridge Service . Enter a desired name in the Service Name field. It is used to identify the service. Then click the Next button. The LAN IP in bridge operating mode is needed for local users to manage the ADSL Modem Router. And no IP address is needed for the WAN in bridge mo...

Page 18 - IV. Configure Wireless Connectivity

IV. Configure Wireless Connectivity 1. Click the Wireless tab on the left frame. A Wireless - Basic page will appear on the right frame. Check the box Enable Wireless . 2. Check the box Hide Access Point and then your WMR-G54 will not respond when a ping is sent by any user on the Internet. This fea...

Page 19 - Europe – EU Declaration of Conformity

Europe – EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been applied in order to prove presumption of compliance with the R&TTE Directive 1999/5/EC: - EN 60950 (2000-06) Safety of Information...

Page 20 - Buffalo Technology Europe; Buffalo Technology UK; Wireless products helpdesk

Buffalo Technology Europe Buffalo Technology UK 176, Buckingham Avenue Slough, Berkshire, SL1 4RD United Kingdom Tel. +44 (0) 1753 555000 Fax. +44 (0) 1753 535420 Buffalo Technology Ireland Free Zone East Shannon Co. Clare Ireland Tel. +353 61 708090 Fax. +353 61 360140 www.buffalo-technology.com ww...

Buffalo Technology WMR-G54 - Manual

Table of Contents:

Summary

Other Buffalo Technology Models